GE Lighting ABV3-Series Albeo LED Luminaire Modular High and Low Bay Lighting Installation Guide
- June 6, 2024
- GE Lighting
Table of Contents
ABV3-Series Albeo® LED Luminaire Modular
High and Low Bay Lighting
Installation Guide
Features
- 5-year warranty
- Damp location rated
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
RISK OF ELECTRIC SHOCK
- Turn the power off before inspection, installation or removal.
- Properly ground electrical enclosure.
RISK OF FIRE
- Follow all NEC and local codes.
- Use only UL or IEC-approved wire for input/output connections.
Minimum size 18 AWG.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAN ICES-005 (A) / NMB-005 (A).
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
Save These Instructions
Use only in the manner intended by the manufacturer. If you have any
questions, contact the manufacturer.
Note: Contact the manufacturer for details and limitations when seeking
to incorporate this product with an emergency system other than Battery
Backup.
Note: CONTACT FACTORY for details and limitations when seeking to
incorporate this product with an emergency system other than Battery Backup.
Prepare Electrical Wiring
Electrical Requirements
The LED driver must be supplied with 120-480 VAC, 50/60 Hz per product label,
and connected to an individual properly grounded branch circuit, protected by
a 15 or 20-ampere circuit breaker.
Grounding Instructions
The grounding and bonding of the overall system shall be done in accordance
with National Electric Code (NEC) Article 600 and local codes.
Albeo® (ABV3- Series)
| White| Black| Red| Green| Violet| Gray
---|---|---|---|---|---|---
French (FR)| Blanc| Noir| Rouge| Vert| Violet| Gris
Portuguese (PT)| Branco| Preto| Vermelho| Verde| Violeta| Cinzento
Spanish (ES)| Blanco| Negro| Rojo| Verde| Violeta| Gris
Troubleshooting
| Symptom | Solution |
|---|---|
| The luminaire will not turn on | • Check that the color of the supply side |
wires match the color of the wires they are connected to.
• Check that all wire connectors are properly connected.
• Verify that your input voltage is within specs.
• If you are using any additional controls (i.e. wireless controls/motion
sensors), please also verify
that those are working properly and that the unit is set up to interface with
the controllers.
GE current
a Daintree company
www.gecurrent.com
© 2021 Current Lighting Solutions, LLC. All rights reserved. GE and the GE
monogram are trademarks of the General Electric Company and are used under
license. Information provided is subject to change without notice. All values
are design or typical values when measured under laboratory conditions.
ALB062 (Rev 04/02/21)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>