telldus 14868 Remote Controlled Outlets User Manual
- June 6, 2024
- TELLDUS
Table of Contents
User manual for Remote
controlled outlets, outdoor use.
facebook.com/telldus
@telldus
You can also read the manual online. Just follow the link:
telld.us/m14868
Features
- Easy installation – no cables or connections are required
- Controls up to 3 channels
- The remote control operates at a distance up to 25 metres (free line of sight)
- LED indicates on/off
- Children protector
- The outlets are TellStick compatible.
WARNING!
- Do not place two outlets too close to each other. The distance between two outlets must be at least 1 m.
- DO NOT OVERLOAD THE OUTLETS!
Do not use the system in the vicinity of inflammable liquids, solvents, colours or similar products.
Installation and pairing an outlet with a remote control
Note! If pairing this outlet with a TellStick please follow the instructions in Telldus Live!
- Remove the plastic tab from the battery in the remote control.
- Connect the outlet to the mains. The LED will flash on/off for 15 seconds or until paired successfully.
- Press one of the ” ” buttons on the remote control within 15 seconds to pair the outlet with that button (The learning mode is automatically disabled if no button is pressed). The LED blinks three times as confirmation.
- Connect a lamp to the outlet. If there is a power switch on the connecting cable, make sure it is switched on.
Unpair a remote control from an outlet
- If the outlet is connected to the mains, disconnect it. Disconnect any connected lamp.
- Connect the outlet to the mains. The LED will flash on/off for 15 seconds or until unpaired successfully.
- Press one of the buttons on the remote control within 15 seconds to unpair the outlet from that button (Learning mode is automatically disabled if no button is pressed). The LED blinks three times as confirmation.
ON/OFF operation of a remote controlled outlet
- Press the button to switch on the power.
- Press the button to switch off the power.
Troubleshooting
Connected lamp does not light:
-
If the outlet LED is lit:
• Check the light source.
• If there is a power switch on the connecting cable, make sure it is switched on. -
If the outlet LED is not lit:
• Check the power supply to the outlet.
• Try pressing the ” ” button on the remote control once again. -
If the problem persists:
• Check the battery in the remote control.
• It may be necessary to repair the outlet with the remote control.
Proove AB, Birger Svensson Väg 34 B,
432 40 Varberg, Sweden
www.telldus.com •
support.telldus.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>