clover FDMINIYJ33G Mini WiFi and 3G User Guide
- June 6, 2024
- clover
Table of Contents
clover FDMINIYJ33G Mini WiFi and 3G User Guide
product Overview
Installation Instruction
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference,
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Part 15 Class B-specific
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Warning
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
FCC exposure limit compliance statement (SAR statement)
This equipment complies with radio frequency (RF) exposure limits adopted
by the Federal Communications Commission for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20 cm between
the radiator & your body.
Innovation, Science and Economic Development Canada (ISED) statement: CAN
ICES-3 (B)/NMB-3(B)
This device complies with ISED’s license-exempt RSSs. Operation is subject
to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
The device could automatically discontinue transmission in case of absence of information to transmit, or operational failure. Note that this is not intended to prohibit transmission of control or signaling information or the use of repetitive codes where required by the technology.
- The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
- The maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall comply with the e.i.r.p. limit; an
- The maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-point operation as appropriate.
In addition, high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices
This equipment complies with IC RSS-102 RF exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body.
CE RF Exposure Compliance
This device meets the EU requirements (1999/519/EC) and the International Commission on Non-Ionizing Radiation Protection (ICNIRP) on the limitation of exposure of the general public to electromagnetic fields by way of health protection.
This device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency range.
IMPORTANT for UK Power Adapter Cord
If the available socket outlet is not suitable for the plug supplied with this equipment, it should be cut off and an appropriate three pin plug fitted. With alternative plugs on approved 3 amp fuse must be fitted in the plug or adapter or in the main fuse box.
NOTE: The plug severed from the mains lead must be destroyed, as a plug with bared flexible cords is hazardous if engaged in a live socket outlet. In the event of replacing the plug fuse, use a 3 amp fuse approved by ASTA to BS 1362, ie carries the mark. Always replace the fuse cover, never use plugs with the fuse cover omitted.
WARNING — THIS APPLIANCE MUST BE EARTHED.
The wires in this mains lead are colored in accordance with the following
code:
Green-and-Yellow = Earth
Blue = Neutral
Brown = Live
As the color of the wiring in the mains lead of this appliance may not
correspond with the colored markings identifying the terminals in your plug,
proceed as follows:
- The wire which is colored Green-and-Yellow must be connected to the terminal in the plug which is marked with the letter “E”, or by the earth symbol or colored Green-and-Yellow.
- The wire which is colored Blue must be connected to the terminal which is marked with the letter “N” or colored Black or Blue.
- The wire which is colored Brown must be connected to the terminal which is marked with the letter “L” or colored Red or Brown.
Clover Network, Inc.
415 N Mathilda Ave Sunnyvale, CA 94085, USA
EU Importer: Marketplace Merchant Solutions Ltd
Unit 9, Richview Office Park Clonskeagh, Dublin 14, Ireland
Patent
clover.com/patents
EU Declaration of Conformity
Hereby, Clover Network, Inc. declares that the radio equipment type, C302E is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: eu.clover.com /eu-compliance
The frequency band and the maximum transmitted power inEU are listed below:
2400MHz – 2483.5MHz: 19.5 dBm (EIRP)
5150MHz – 5250MHz: 20.5 dBm (EIRP)
5250MHz – 5350MHz: 26 dBm (EIRP)
5470MHz – 5725MHz: 26.5 dBm (EIRP)
The following LTE band power is only for
C302E LTE Band 3:23 dBm (conducted)
LTE Band 7: 23 dBm (conducted)
LTE Band 20: 22.5 dBm (conducted)
NFC (13.56MHz): -11.33 dBpA/m (@10m)
Restrictions in AT/BE/BG/CZ/DK/EE/FR/DE/IS/1E/IT/EL/ES/CY/LV/LI/LT/LU/HU/MT/NL/NO/PL/PT/RO/S1/ SK/TR/FI/SE/CH/UK/HR. 5150MHz-5350MHz is for indoor use only.
Caution: Exposure to Radio Frequency Radiation
This equipment complies with EU radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Clover Mini (2nd generation) Model Number: C302U (United States and Canada)
FCC ID: HFS-C302U IC: 1787B-C302U
Model Number: C302U (Wi-Fi) FCC ID: HFS-C302W IC: 1787B-C302W HVIN: C302W
Model Number: C302L (Argentina) CNC ID: C-22360
Model Number: C302E (Europe) The FCC ID & IC certificate are not applicable to
C302E and C302L
Clover Mini (2nd generation)
Model Number: C302U (United States and Canada)
FCC ID: HFS-C302U
IC: 17876-C302U
Model Number: C302U (Wi-Fi)
FCC ID: HFS-C302W
IC: 17876-C302W HVIN: C302W
Model Number: C302L (Argentina)
CNC ID: C-22360
Model Number: C302E (Europe)
The FCC ID & IC certificate are not applicable to C302E and C302L
Waste Electrical and Electronic Equipment-WEEE
NOTE: This product is covered electronic equipment under the European Union’s Waste from Electrical and Electronic Equipment (“WEEE”) Directive (2012/19/EU). The WEEE Directive requires that covered equipment be collected and managed separately from typical household waste in all EU member states. Please follow the guidance of your local environmental authority or ask the shop where you purchased the product for collection or recycling options.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>