clover Flex Venta Sistema User Guide
- June 6, 2024
- clover
Table of Contents
clover Flex Venta Sistema
Instructions
FCC Part15
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, (2) This device must accept any interference received, including
interference that may cause undesired operation.
FCC Part 15 Class B-specific
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the recieving antenna.
- increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Warning
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Radiation Exposure Statement
The product comply with the FCC portable RF exposure limit set forth for an
uncontrolled environment and are safe for intended operation as described in
this manual. The further RF exposure reduction can be achieved if the product
can be kept as far as possible from the user body or set the device to lower
output power if such function is available.
Innovation, Science and Economic Development Canada (ISED) statement:
CAN ICES-3 (B)/NMB-3(B)
This device complies with ISED’s licence-exempt RSSs. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Le present appareil
est conforme aux CNR d’ ISED applicables aux appareils radio exempts de
licence. L’exploitation est autorisee aux deux conditions suivantes : (1) le
dispositif ne doit pas produire de brouillage prejudiciable, et (2) ce
dispositif doit accepter tout brouillage rec,u, y compris un brouillage
susceptible de provoquer un fonctionnement indesirable.
Caution:
- The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
- (the worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in Section 6.2.2(3) shall be clearly indicated.
- Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.
- Avertissement:
Le guide d’utilisation des dispositifs pour reseaux locaux doit inclure des instructions precises sur les restrictions susmentionnees, notamment :
Radiation Exposure Statement:
The product complies with the Canada portable RF exposure limit set forth for
an uncontrolled environment and are safe for intended operation as described
in this manual. The further RF exposure reduction can be achieved if the
product can be kept as far as possible from the user body or set the device to
lower output power if such function is available.
EU Declaration of Conformity
Hereby, Clover Network, Inc. declares that the radio equipment type, C403 is
in compliance with Directive 2014/53/EU. The full text of the EU declaration
of conformity is available at the following internet address:
eu.clover.com/eu-compliance
The frequency band and the maximum transmitted power in EU are listed below:
-
WWAN
-
LTE Band3: 22.5 dBm (Conducted)
-
LTE Band7: 23 dBm (Conducted)
-
LTE Band20: 22 dBm (Conducted)
WLAN -
2400MHz-2483.5MHz: 16.5 dBm (EIRP)
-
5150MHz-5250MHz: 19.5 dBm(EIRP)
-
5250MHz-5350MHz: 19.5 dBm(EIRP)
-
5470MHz-5725MHz: 21.5 dBm(EIRP)
NFC: 3.84 dBuA/m @ 10m
CE maxSAR 10g: Body 1.44 k/g :w/kg
Restrictions
AT/BE/BG/CZ/DK/EE/FR/DE/IS/IE/IT/EL/ES/CY/LV/LI/LT/LU/HU/MT/NL/NO
/PL/PT/RO/SI/SK/TR/Fl/SE/CH/UK/HR. 5150MHz-5250MHz is for indoor use only.
Caution: Exposure to Radio Frequency Radiation
This product complies with EU requirements regarding restriction of exposure
of persons to radio-frequency energy (RF) emitted by telecommunication and
radio devices as it is designed and manufactured in such a way as not to
exceed the exposure limits indicated by the European Union Commission. The
permitted SAR limit for the general population is 2.0 W/Kg for body and 4.0
W/Kg for limb. This limit guarantees an ample safety margin that protects all
persons regardless of age and health condition. SAR is measured with the
device at 5mm to the body and at 0mm to the extremity, while transmitting at
the highest certified output power level in all frequency bands of the device.
The highest SAR level recorded for this model was equal to body 1.44W/Kg, &
limb 2.28 W/Kg.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>