E13 607 94 Vadsbox Rum User Manual
- October 27, 2023
- VADSBO
Table of Contents
E13 607 94 Vadsbox Rum User Manual
English:
Vadsbox is a junction box intended for the fitting of products such as dimmers, control modules and relays. Vadsbox is IP20 compliant and intended for placement in suspended ceilings or for surface mounting indoors. 5-pole spring connector, which can be removed from the fitting if necessary. Vadsbox’s base plate includes brackets which, with the help of the included cable ties, allow for a universal fitting of products, as well as simple internal cable Hanagement and strain relief.
Dimensions
Cable entry options/Opciones para la entrada de cables/
Installation manual CBU-A2D
Warning!
High voltage. Risk of electric shock. The installation should only be carried out by an authorised electrician.
CBU-A2D is a Bluetooth controllable, Casambi enabled 2 channel 0-10V/ DALI
controller. CBU-A2D has a universal 100-277 VAC input voltage range. CBU-A2D
can control one or two 0-10V controllable LED drivers, or it can control a
tunable white LED driver with two 0-10V control interfaces.
The product can also be configured into a DALI mode where it can be connected
to a DALI LED driver or DALI sensor for presence and/or daylight harvesting
functions.
CBU-A2D can be controlled with Casambi app which can be down- loaded free of
charge from Apple App Store and Google Play Store.
CBU-A2D can be controlled with Casambi app which can be downloaded free of
charge from Apple App Store and Google Play Store.
Different Casambi enabled products can be used from a simple one luminaire
direct control to a complete and full fea-tured light control system where up
to 250 units form automatically an intelligent mesh network.
Technical data
Installation
Make sure that the mains voltage is switched off when making any connections.
Use 0.5-1.5 mm2 solid or stranded conductor electrical wires. Strip the wire
6-7 mm from the end. Insert the wires into the corresponding holes and tighten
the connector screws.
If the connected LED driver cannot be turned off completely from the control
interface, an external relay with 12 VDC coil can be connected to channel 2.
Make sure the relay is protected against flyback voltage, e.g. do not use a
PCB relay without the flyback diode. A suitable fixture configuration must be
selected in order to control a relay.
CBU-A2D, as any other Casambi product, should not be placed in a metal enclosure or next to large metal structures. Metal will effectively block radio signals which are crucial to the operation of the product. A thorough connectivity testing is strongly recommended in the installation site.
Range
The range between two CBU-A2D units or between a CBU-A2D and a smart phone can
vary a lot depending on obstacles and surrounding material. In open air the
range between two CBU-A2Ds can be in excess of 200 ft, but if the unit is
encapsulated into a metal structure, the range can be only few feet.
Therefore, thorough testing is highly suggested.
Casambi uses mesh network technology so each CBU-A2D acts also as a repeater.
When testing the network, it is important to test that each unit can be
controlled from any point of the network covered area.
Read More About This Manual & Download PDF:
References
- kgf.cm - kgf Resources and Information.
- Vadsbo LightTech AB – Vi utvecklar, designar och säljer trådlösa ljusstyrningslösningar för stora & smarta projekt.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>