COBY CETW516 Wireless Earbuds User Manual
- June 5, 2024
- COBY
Table of Contents
COBY CETW516 Wireless Earbuds
WHAT IS INBOX
HEADPHONE
Overview
CETW516 True wireless stereo earbuds
Charging case for the CETW516
Charging
Charging the charging case
The charging case’s LED indicator light will flash red to indicate it has successfully begun charging. When it is fully charged, the LED indicator turns steady red.
Charging your earbuds
Earbuds
| ****
Low battery
| Slowly flashing red
__
Tone notification
---|---|---
| Charging| Steady red
Fully charged| Off, LED light is off
Powering on/off
Powering on
Your CETW516 Earbuds will power on automatically when taken out of the charging case. You can also power them on manually by pressing and holding the Multi-Function Button (MFB) on both earbuds for 7 seconds.
ON
| Flashing blue
---|---
Power on
tone notification
Powering off
Your CETW516 Earbuds will power off automatically when placed back in the
charging case.
To power them off manually, press and hold the Multi-Function Button (MFB) on a single earbud for or 7 seconds.
Off
| Flashing red three times (both earbuds)
---|---
Power off tone notification
Pairing
True Wireless stereo connection
When the Earbuds are turned on, it will automatically enter True Wire-less
stereo pairing mode.
Enter True Wireless stereo pairing mode| Alternating flashing red and
blue on both earbuds
---|---
When True Wireless Stereo connection is suc- cessful (the right earbud is
connected to the left earbud).| | Left earbud: Alternating flashing
red and blue
Right earbud: Flashing blue
Connected tone notification
Bluetooth connection with your device
After a successful True Wireless stereo connection, your CETW516 will automatically enter Bluetooth pairing mode with your media device. Turn on Bluetooth in your device’s settings and search for “CETW516”, then tap “CETW516” to connect.
Pairing mode
| Alternating flashing red and blue
on the left earbud.
---|---
Connected to a device (Successfully paired with your media device).|
Flashing blue (both earbuds)
Connected tone notification
The earbuds will automatically be paired with your last sucessfully connected media device next time they are turned on.
Controls
Music mode
Phone call mode
Voice Assistant mode
Troubleshooting
| Problem | Solution |
|---|
Your earbuds aren’t con- necting to each other. The Earbud LED Indicators on both earbuds are alternating between red and blue lights.| Double press the Multi-Function Button on either earbud to manually initiate True Wire stereo connection. Please allow up to 30 seconds to connect if you are in a public area with interfering signals.
Your earbuds are connected to each other, but you can- not connect to my device (phone, laptop, tablet etc.)
| Ensure the earbuds are not cur- rently connected to another device. If they are, open Bluetooth settings on those devices and tap “Forget device” on “CETW516”. Confirm the device you would like to pair with is Bluetooth enabled, please refer to that device’s user manual to confirm.
There is no response on the CETW516 earbuds.
| Firstly, check whether the batteries in earbuds are depleted, if they are, charge the earbuds. If they are not, reset the earbuds by pressing and holding the Multi-Function Button for about 8 seconds.
You can only hear sound on one earbud.
| Reset the earbuds by pressing and holding the Multi-Function Button for about 8 seconds.
Specifications
| Model Name | CETW516 |
|---|---|
| Power Input | 5 V/1A |
Charging time
| Charging case: 1.5 hours
Earbuds: 1.25 hours
Playtime (Earbuds)| Up to 5.5 hours
Playtime (with charging case)| Up to 20 hours
Battery Type| Rechargeable Lithium-ion
Range| 10m/33 ft
Bluetooth version| V 5.0
Dimension| 2.52 x 1.90 x 0.98”
Weight (earbuds alone)| 8 g/ 0.28 oz
Weight (with charging case)| 37g
Specifications are subject to change without notice.
Safety Statement
Safety Precautions
- Avoid dropping.
- Do not disassemble this device.
- Do not expose this device to rain or moisture or submerge in water.
- Ideal temperatures are 0°C to 35°C. Avoid extreme temperatures.
- Keep the device away from excessive heat, such as sunshine, fire or the like.
- Do not use the device outdoors during thunderstorms.
- Use original or certified cables.
- Do not use any corrosive cleaner/oil to clean.
- Keep out of reach of children. It contains small parts which may be a choking hazard.
- Observe local laws and regulations while using the device.
- To prevent damage to your device’s parts or internal circuits, do not use it in dusty, smoky, damp or dirty environments.
- Do not use, store or transport the device where flammables or explosives are stored. Using your device in these environments increases the risk of explosion or fire.
Hearing Safety
- To avoid hearing damage, do not listen for extended periods at high volume.
- Do not turn the volume so high that you’re unable to hear your surroundings.
- Do not use earphones while driving.
- You should use caution or temporarily discontinue use in potentially hazardous situations.
FCC Statement
FCC ID: 2AMSOETW001
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation. Warning: Changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: (1) Reorient or
relocate the receiving antenna. (2) Increase the separation between the
equipment and receiver. (3) Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. (4) Consult the dealer
or an experienced radio / TV technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Notice
This product complies with the radio interference requirements of the European Community. This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Follow local rules and never dispose of the product and rechargeable batteries with normal household waste. Correct disposal of old products and rechargeable batteries helps prevent negative consequences for the environment and human health.
Disclaimer
All information, design and specifications contained in this manual were
correct at the time of this publication. As the product goes under continuous
upgrades and changes, however, the final device may have slight differences.
The contents of this manual are subject to change without prior notice, and
Coby will not be liable for any errors contained herein or for incidental or
consequential damages in connection with the furnishing performance or use of
this manual. COBY® IS A REGISTERED TRADEMARK OF HEARST COMMUNICATION, INC. AND
USED UNDER LICENSE BY SUMMIT ELECTRONICS, LLC. 2021 HEARST COMMUNICATION, INC.
ALL RIGHTS RESERVED AND ANY USE OF SUCH MARKS BY SUMMIT ELECTRONICS LLC IS
UNDER LICENSE. OTHER TRADEMARKS AND TRADE NAMES ARE THOSE OF THEIR RESPECTIVE
OWNERS.
WARNING: CANCER AND REPRODUCTIVE HARM –
WWW.P65WARNINGS.CA.GOV.