vadsbo LDN200KRON Double Dimmer User Manual
- June 5, 2024
- VADSBO
Table of Contents
LDN200KRON
The LD200KRON dimmer is controlled by one or more retractive 1-pole switches (rocker switch) per control input.
- Starts at 0VA on both channels.
- Up to 100VA per channel (2 x 100VA max).
- Two separate channel outputs.
- Two separate control inputs.
- Can be mounted in the wall box behind the push button.
- Used for dimmable LED, energy-saving lamps, and incandescent bulbs (E27, E14, GU10) from 0VA up to 100VA per channel.
- Used for dimmable LED drivers from 0VA up to 100VA per channel.
- Used for low voltage halogen up to 100VA per channel.
- Can be dimmed with several parallel-connected pushbuttons per channel input.
- Retains the last light level after power failure.
- With an individually settable minimum dimming level, per output.
- Automatic resettable overload and temperature protection.
- Self-resettable short-circuits protection per channel.
Wiring diagram
Operation
Off/On – A gentle and quick push. The dimmer is turned on with the latest
selected light intensity (memory function). Diming up/down – Gently press, and
keep pushing, until the desired right intensity is obtained. The dimmer will
stop at the maximum and minimum levels.
Note! Keep in mind that, depending on the brand, the LED and low energy can
consume up to twice the rated power (reactive power).
Adjusting the lowest dimming level
The last used channel output will set which minimum dimming level it is
applied to. If channel 1 was the last channel to be dimmed, the potentiometer
will then set the minimum dimming level for channel 1.
If channel 2 was the last channel to be dimmed, the minimum dimming level
potentiometer will set channel 2. As an example, this means that you can load
downlights on one of the channels and bulbs on the other.
Adjust the lowest dimming level by rotating the rotary potentiometer with a
screwdriver. Dim up and down to examine the result and then change the rotary
potentiometer´s position again if needed.
Please note that energy lamps and LEDs consume less power than incandescent
light and halogen, hence the lowest dimming level may vary.
Rev 07-11-2016
Technical data
Item number: | V-4020020IBK |
---|---|
Rated voltage: | 230V +/-10% 50Hz |
Max. current: | 0.43A / channel |
Min. load | 0VA |
Max. load: | 100VA / channel |
IP grade: | IP20 (for indoor use) |
Dimension: | Ø57×21 mm |
Cable area | 1,0-2,5mm2 (AWG 12-22) |
Vadsbo Transformatorer AB
Tel: 031-23 56 00
info@vadsbo.net
www.vadsbo.net
References
- Technical Guides | Support Library | CP Electronics
- Vadsbo LightTech AB – Vi utvecklar, designar och säljer trådlösa ljusstyrningslösningar för stora & smarta projekt.