FULAIM X3 Wireless Magnetic Microphone System Owner’s Manual

FULAIM X3 Wireless Magnetic Microphone System

Overview

Thank you for choosing our Wireless Microphones.
This device adopts 2.4G AFH (adaptive frequency hopping) and innovative digital wireless low-latency technology,provides high quality audio, stable and reliable signal transmis­sion. It can be widely used in interviews, short video recordings, program hosting, live streaming, teaching and training, and other wireless applications.

This product is available in the following different delivery includes:

Model| Transmitter| Receiver| Furry windscreen| Recharging cable| Recharging cable| Magnetic plate
---|---|---|---|---|---|---
X3s Type-C standard version| ****

x2

| ****

Receiver (Type-C)x1

| ****

x2

| ****

X 1

| ****

No

| ****

x2

x3 Lightning standard version| ****

x2

| ****

Receiver (Lightning)x1

| ****

x2

| ****

X 1

| ****

No

| ****

x2

X3 Cellphone charging case version| ****

x2

| Receiver (Type-C)x1+

Receiver (Lightning)x1

| ****

x2

| ****

X 1

| ****

xl

| ****

x2

The user interface of a transmitter(TX)

Power/Status indicator

| lights in blue| Connected and fully charged
flashes in blue| Not connected and fully charged
lights in red| Connected and low battery
flashes in red| Not Connected and low battery
lights in red while charging| under charging
lights in blue while charging| fully charged
Noise reduction indicator| lights in blue| noise reduction is on
lights off| noise reduction is off

User Interface of receiver (RX)-cell phone version

Start using

How to use on cell phone:

1. Connect the RX with the cell phone.
2. Tum on the TX, start to use when the connection indicator of both TX and RX lights on.
3. Set the RX output volume as level 2-3; You can charge the cell phone through the RX and use it while charging.

*For some cell phones with Type-C port, you need to turn on the OTG function in the phone setting section.

Precautions

1. This product is a precise electronic device, which should avoid watering or heavy falls; if it gets wet, please dry it in time, and hand it up to professional technician for further checking.
2. When not using for a long time, the built-in rechargeable Li battery should be fully charged every three months to maintain the high performance of the battery.
3. The built-in battery must not be exposed to sunlight, fire, or similar overheating environment.
4. To avoid intermittent signal, please try to keep the transmitter and receiver face to face while using.

Specifications

Recharging case:

• Open the lid can activate the indicator to check the remaining battery power.
• Close the lid will enter the charging mode automatically.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compli­ance could void the user’s authority to operate the equipment

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and.if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However. there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception.which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF warning for Portable devices:

• The device has been evaluated to meet general RF exposure requirement, The device can be used in portable.

The image shown here is indicative only. If there is inconsistency between the image and the actual product, the actual product shall govern.
We reserve the rights to improve product and product copyright information without prior notice.

Read this manual carefully before using the product and store it properly.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>