HYPERGEAR 14668 ChargePad Pro Wireless Fast Charger Pad Compatible User Manual
- June 6, 2024
- HyperGear
Table of Contents
14668 ChargePad Pro Wireless Fast Charger Pad Compatible
User Manual
IMPORTANT
Read all safety instructions and warnings prior to using this product.
Improper use and failure to follow safety guidelines could result in hazards,
injury, and/or property damage that is not the manufacturer’s responsibility.
The user is responsible for maintaining this product with care for maximum
use.
Use only the included adapter or a certified 3rd party QC 3.0 adapter to power
this device. Standard adapters may damage the charger or cause a fire hazard.
Do not place metal objects, magnets, magnetic stripe cards, and hard-drive-
based devices near the wireless charger, It may cause data corruption,
Do not attempt to modify, disassemble, or repair this product.
Do not expose to water, moisture, or extreme temperatures (below 40 F or above
90″ F)
Under any circumstances, if you find this product rapidly increasing in
temperature, emitting an odor, or demonstrating an abnormal phenomenon,
discontinue use immediately.
Wireless Charger|
---|---
Wall Adapter|
Micro USB Cable|
NOTE: This charger is designed for Qi-compatible devices. If your phone does not have built-in Qi wireless charging capabilities, please use a certified Qi wireless charging case or receiver. Refer to your phone’s user manual for detailed features and functions.
IMPORTANT
X NO Metal
X NO Magnets
X NO Thick Case
Phone cases that contain metal, magnets, or are thicker than 3mm will interfere with wireless charging.
INSTRUCTIONS
Connect the wireless charger to a power source using the included cable and
adapter.
NOTE: Fast Charge mode requires use of the included wall adapter.
Standard 1A or 2A adapters are not powerful enough for this charger and
may cause it to malfunction or overheat.
Place your phone onto the charger. Your phone will indicate when charging
begins.
LED Status Charging
The LED will light BLUE to indicate charging. The light will disappear after 5
seconds.
Foreign Object Detected
If the LED is flashing, remove any foreign objects that may affect charging
(such as metal plates and other objects) from the charging area.
It’s normal for a wireless charger and your device to become warm while
charging.
LIMITED ONE YEARW WARRANTY
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF exposure guidelines, This equipment
should be installed and operated with a minimum distance of 20cm the radiator
your body: Use only the supplied antenna.
FCC ID:2AQ5C-HYP15WPSM
Contact info@myhypergear.com to submit a
warranty claim.
Proof of purchase is required.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>