NATIVE UNION SNMAG01 Snap Magnetic Wireless Charger Instruction Manual
- June 6, 2024
- NATIVE UNION
Table of Contents
NATIVE UNION SNMAG01 Snap Magnetic Wireless Charger
SPECIFICATION
- INPUT
- DC 5.0V
- 3.0A; DC 9.0V
- 2.22A; DC 12.0V
- 1.67A
- OUTPUT
- 5W / 7.5W / 10W / 15W
- FREQUENCY
110kHz – 148kHz
SAFETY INFORMATION
INFORMATION
This product is intended for home & office use. 2. For indoor use only. 3. Consult local staff before using the product nearmedical or industrial equipment or on board an aircraft. 4. Prevent cables from being pinched or damaged. 5. A damaged cable or device may malfunction and/ or overheat. (Fire hazard). 6. Unplug the product if not used for an extended period of time.
REGULATORY INFORMATION
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures: Reorient or relocate the receiving antenna | Increase the
separation between the equipment and receiver | Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected |
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter. FCC ID: X3QSNMAG01
EUROPE ˜ EU DECLARATION OF CONFORMITY
Hereby, Design Pool Limited declares that the product SNMAG01 is in compliance
with directive 2014/53/EU. The full text of the EU DoC is available online:
nativeunion.com/product-compliance
Manufacturer
Design Pool Limited. 33/F, 88 Hing Fat Street, Hong Kong –
support@nativeunion.com EU: Design Pool SAS, 146
rue Montmartre, 75002 Paris, France
Made in China
References
- Tech Accessories Reimagined | Native Union
- Product Documentation – Native Union
- Product Documentation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>