NATIVE UNION SMPD02 Smart Charger PD 20W Instruction Manual
- June 5, 2024
- NATIVE UNION
Table of Contents
NATIVE UNION SMPD02 Smart Charger PD 20W Instruction Manual
WHAT IS INSIDE
HOW TO CONNECT
SPECIFICATION
SMART CHARGER PD (MODEL No: SMPD02)
Input: AC 100-240V – 0.5A, 50/60Hz Class II
Output: Type A: DC 5.0V 2.4A
Type C: DC 5.0V 3.0A ; DC 9.0V 2.22A ; DC 12.0V 1.5A
Total Output: 20.0W
BR Number: 50401444-000
Average active efficiency: 80.55%
Efficiency at low load: 73.82%
No-load power consumption: 0.11W
HOW TO INSTALL
SAFETY INFORMATION
- This product is intended for home & office use.
- For indoor use only.
- Safety standards: IEC62368-1: 2014 (2nd Edition).
- Do not drop the product or submit it to impact.
- Do not place the product in an area exposed to heat, direct sunlight, dampness, moisture, rain, vibration, shock, dust or sand, excessive vibration or near any kind of magnet.
- The connector of this transformer cannot be replaced.
- The disconnection from line voltage is made by pulling the mains plug
- The socket-outlet shall be installed near the equipment and shall be easily accessible.
- Use only with high quality, undamaged USB cables.
- Prevent cables from being pinched or damaged.
- A damaged cable or device may malfunction and/or overheat. (Fire hazard)
- Unplug the product if not used for an extended period of time.
DOC Declaration of Conformity (Europe)
Hereby, Design Pool Limited declares that the product SMPD02 is in compliance with Directive(s) 2014/30/EU & 2009/125/EC. The full text of the EU DoC is available at the following internet address.
nativeunion.com/product-documentation
REGULATORY INFORMATION
FCC Statement (USA)
FCC responsible party: Design Pool LLC
(dba Native Union) C/O Armanino LLP, 11766 Wilshire Blvd Fl 9, Los Angeles, CA
90025-1586
Telephone +1 (855) 969 5525
CONFORMS TO UL STD.62368-1
CERTIFIED TO CSA STD. C22.2 NO. 62368-1
CAN-ICES-3(B)/NMB-3(B)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>