Zetronix Atom Pro 2.7K SuperHD D.I.Y Surveillance Camera Kit User Manual
- June 6, 2024
- Zetronix
Table of Contents
Zetronix Atom Pro 2.7K SuperHD D.I.Y Surveillance Camera Kit User Manual
DIAGRAM
- Main Board
- Camera
- Battery
- Light Indicator
- MicroSD card Slot
- USB charge port
- Mic
- Audio Out
- PIR Sensor
- IR Sensor
Charging
Please ensure you have a full charge before using the Atom. Connect the battery 3 to the mainboard 1 and connect the mainboard’s USB charge port 6 to a USB charger.
Storage
Please install a MicroSD memory card before recording any media. Insert a MicroSD card into the slot 5 by pushing it in as far as it will go until you feel it click in place. Push it in again to remove it so it toggles back out.
Power ON/OFF
Hit the power button on the remote to turn the camera device on the Atom on or off. When turning it on, the red and green light will flash and the camera device will go into motion activated recording mode by default. To pause recording hit record button on the remote.
OPERATION
Recording Modes
The Atom has 3 modes or operation; Motion Activated, Continuous Recording and PIR Motion Recording. Before changing its recording mode, please ensure the camera is on standby (solid green light 4) where video is not currently being recorded. To pause any recording, press the video record 14 button at any time.
Continuous Recording
Press the video record button 14 to start recoding. The green light will flash
3 times and go out indicating recording has started. Pause the recording by
pressing the video record button 14 again
Motion Activated Record
Press the motion detect button 13 to go into motion activated mode. Anytime
there’s a change in the video image video will start recording. The indicator
light will flash 3 times and go out. Hitting the motion detect button 13 again
will stop the recording putting the camera device back into stand by mode
indicated by a solid green light 4. When recording is triggered by motion, the
camera will record for one minute before it stops.
PIR Motion Video Recording
Hit the PIT motion detect button 15 to go into PIR motion activated mode.
Video will recording anytime theres motion in front of the PIR sensor 9. The
light will blink 3 times and go out. Hitting the PIR motion detect button 15
again will stop the recording putting the camera back into stand by mode
indicated by a solid green light 4. When recording is triggerd by motion, the
camera will record for at least a minute before it stops going back to standby
Taking Photos
Ensure the camera is on standby with a solid green light 4, then press the
photo button 12 to snap a picture. The light 4 will flash once indicating the
picture was saved.
ADVANCED SETUP
Date/Time Stamp
To change or remove the date-time imprinted on the video or photos, please use
the zUtilityApp software that can be downloaded from our website. Once
installed, choose
Atom-PRO from the items menu and follow the instructions in the app.
https://www.zetronix.com/download
Media Playback
To view the recorded media, you can connect the Atom directly to your
computer’s USB port using a USB cable connected to the mini USB port 4, or use
a MicroSD card adapter to connect the MicroSD memory card directly to the
computer. Your computer should automatically prompt you to review the media or
browse the files.
To playback the videos we recommend using VLC player which can be downloaded for free: http://videolan.org
Troubleshooting
If the Atom stops responding, first check that the battery is charged, the remote battery is good, and the memory card is not full.
Most issues can be solved by resetting the Atom, or formatting the MicroSD card in your computer.
To reset the Atom press and hold the reset button y for 5 seconds, the Atom should power off. Then try operating it as usual.