Zetronix XS8 Pro Solar Powered Rotating Security Surveillance Camera User Manual
- May 15, 2024
- Zetronix
Table of Contents
4G
Solar Powered Rotating
Security Surveillance
Camera
XS8 Pro
User Manual
Product and Packing List
1.1 Product Picture:
1.2 Packing list
Product Diagram
1.3 Process
- Solar panel: connect panel to camera, fix a suitable angle with screws
- Sim card and TF card: loosening the cap in the above remark
- Insert sim card and TF card, then tighten the screws.
- Power Cable: Connect the cables between the panel and camera, then tighten the waterproof cap.
- Panel power-on: Remove the rubber of panel, make sure it is power on. Then put the rubber back to the panel.
Installation
APP Installation
- Open the app then input your E-mail address then press “Register. Check and select to agree the agreement then your Email box will get a verification code. (For better user’s experience, please allow to open all permissions to avoid missing any notification from the app)
|
---|---
https://apps.apple.com/cn/app/ubox/id1436112326| https://play.google.com/store/apps/details?id=cn.ubia.ubox - Input the “Verification Code” and press “Next” (“If it’s not in your inbox, please check your spam folder”)
- Set the login password and confirm the login password. Then press “Register” to next step (For your password safety, the password requires more than 8 characters plus a combination of letters)
- Enter your e-mail address, and input your login password. Then press “Login”
4. Adding 4G Camera to UBOX APP
- Make sure to test your Sim card if it’s working on your mobile phone and has data credit before inserting it in the camera.
- If you have only just activated your Sim card it may take up to 24 hours to work depending on your carrier.
- Make sure there is a signal/reception in the area where the camera is located.
- Insert Sim card correctly.
Steps :
-
Go to Device tab from the bottom left-hand corner.
-
Click “Setup 4G Device”.
-
Wait for the blue light then click “Next”.
Note: If you do not have a blue light showing on the camera and the light is red do not hit next, the camera will not set up correctly. So, you must wait for the blue light to turn on. In some cases, it can take up to 90 seconds. -
Scan the QR Code on the camera to connect your phone.
-
Wait for few seconds to connect.
-
Name the device, then click “Next”
-
You will get a prompt that camera has been installed successfully
Device Settings
Read User Manual Online (PDF format)
Loading......