Zetronix Soliur-XT30 Intelligent Solar Energy Alert PTZ Camera User Manual
- June 8, 2024
- Zetronix
Table of Contents
Zetronix Soliur-XT30 Intelligent Solar Energy Alert PTZ Camera User Manual
PRODUCT
PACKING LEST
- l Screw kit
- 1 Hexagon spanner
- l Screw driver
- 6 Screws
- 6 Tapping screw
- 1 USB charging cable
PRODUCT DIAGRAM
Quick Setup
Insert the USB cable of solar panel to the “USB” Silicon Flap on the bracket
base for batterty charging.
Press the Power switch to turn ON/OFF the camera,
Wait the voice prompt step by step for pairing the camera with the APP. Note : Before you turn on the camera, please close the silicon flap to avoid rain leakage.
Make sure your phone is connecting to the 2.4Ghz wifi firstly before you pairing the camera.
INSTALLATION
APP INSTALLATION
Search and download” tuya” in major applicatio markets or scan the QR code
below to download the APP.
Once you download the APP to your smart phone, you may enter the first page which you can Login with existing account or register. ( If you are the new user of Smart Life and don’ t have an account, please choose register first and follow the below screenshots to complete the registration. )
( If you have the existing account, there are two ways to login, one is with
SMS verification Code, the other one is with password. In case you forget the
password, you may choose login SMS verification Code or you can choose forgot
password to reset it by Entering Verification Code which sent to you mobile
via message. )
Once the account has been setup successfully, then you will automatically
enter the page of “add device”, kindly follow below steps to add the camera.
ADD DEVICE OR CLICK ON TOP OF RIGHT ON THIS
CHOOSE SECURITY AND SENSOR AND FOLLOW THE SCREENS BELOW.
You may choose next stop to go to QR code paring mode or you may go to “other
Mode”on top of right to enter the page of choosing QR Code Net-pairing or
Smart configuration, if you choose the “next step”,you may follow the below
screenshots:
If you choose ” the other mode ” on the top of the right side, you may find QR Code Net-pairing Which you will go back to the “Add device”page and process it again like above procedure. Or you can choose “Smart configuration”and follow the below screenshots and after that you will see the device added successfully.
FAQ:
After the configuration is done, our device will be showed on Smart Life APP which enable you to surf the smart living easily. If you have any questions about App using, you may go to category” me”to find the” Help Center”and check if you have the same issues. If not, you can report the issue and then your problems will be handled and answers will be given soon if you provide as much information as you can.
Safe Battery Handling and Usage
DO NOT allow the batteries or battery compartment to get wet prior to or during installation while your Wire-Free camera is weatherproof and safe to use outside.