Westinghouse W-687 LED Indoor Lighting Fixture Owner’s Manual

Westinghouse W-687 LED Indoor Lighting Fixture Owner’s Manual

INSTALLATION STEPS

NOTE: Instructions apply to both round and square slim recessed LED downlights.

1. Use the hole size template included in box to drill the hole in ceiling. Prepare supply wires: Remove 6″ of the outer insulation of the line voltage cable (15cm) and strip wires 5/8” (1.6cm). (Fig.1)
   

2. Open the hardwire box swing cover and remove the appropriate knockout, insert the electrical supply wire through the knockout. Use the wirenuts to connect the white wire from the supply wire with the white wire of the junction box. Match the black wire from the supply wire with the black wire of the junction box. Match the copper wire from the supply wire and with the green wire of the junction box. (Fig. 2)
   

3. Connect junction box to recessed LED panel with the quick lock connector. (Fig. 3)

4. Place junction box into the ceiling through cut-out. (Fig. 3)
   

5. Pull the spring clips on the fixture up and through the cut-out. Spring clips should close above the ceiling and secure recessed LED module in place. (Fig. 4)
   

CLEANING AND CARE

To clean, wipe fixture with soft cloth. Clean glass with mild soap. Spray from chemical cleaners can discolor the finish of fixture. Do not use scouring pads, powders, steel wool or abrasive paper to clean this fixture.

ASSEMBLY INSTRUCTIONS FOR INDOOR LIGHTING FIXTURE

Congratulations on your Westinghouse purchase. This fixture has been designed to give you many years of beauty and service. For questions and comments, please visit www.westinghouselighting.com/contact- us

NOTE: Carefully unpack fixture and parts. Make sure all parts are included before discarding any packing materials.

NOTE: THIS FIXTURE IS SUITABLE FOR USE WITH DIMMABLE SWITCHES, SEE BELOW FOR LIST OF COMPATIBLE DIMMERS.

10-100%

MACL-153MH-WH, P-PKG1W-WWH-R
Leviton| R62-06674-P0W, R12-06672-1LW
Eaton| SAL06P-LA-K

Not recommended for use with motion sensors, light sensors, timers or any other external controls.

WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.Not recommended for use with motion sensors, light sensors, timers or any other external controls.

1. Read all instructions carefully before installation and operation.
2. If you are not familiar with federal, state, and local electrical codes, it is recommended that you consult with a qualified electrician.
3. Suitable for wet location. The driver housing is mounted inside the ceiling, which can not be reached by the the water, which should be installed by qualified electrician.
4. Non-replaceable LEDs.
5. Caution: LEDs emit bright light. Avoid looking directly into the light source for prolonged periods to avoid eye damage.
6. Not to be used with electronically controlled switches.

WARRANTY INFORMATION

This luminaire is warranted to be free from defects in materials and workmanship for 5 years. If the product fails during the warranty period, return defective product to seller. Warranty terms and conditions of seller apply. If replacement product is not available through seller, please contact www.westinghouselighting.com/contact-us.

Westinghouse Lighting, Philadelphia, PA 19154-1029, U.S.A. www.westinghouselighting.com

WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF are trademarks of Westinghouse Electric Corporation.
Used under license by Westinghouse Lighting.
All rights reserved.
Made in China

References

• Ceiling Fans | Lighting Fixtures | Lamps
• Contact Us

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>