Cabela s PG21275350 Flashlight User Manual

Cabela s PG21275350 Flashlight

Switch Operation

Cabela’s CTL Flashlights have multiple modes that are each activated by pressing the tailcap switch. Depending on the model, modes include High, Medium, Low, Momentary, and Strobe.

•  Press the tailcap switch completely to turn the light on. This will be the High illumination setting.
•  With the light on, press switch halfway and release quickly to switch between High, Medium (1000/1200 models only), and Low brightness settings. Press the switch completely to turn off.
•  With the light, off, press the tailcap switch halfway, release quickly, then immediately press completely to turn the light to strobe mode. Press the switch halfway and release quickly to switch between settings. Press switch completely to turn off.
• For momentary light operation, press the tailcap switch halfway and hold. This will turn on the High illumination setting. Release tailcap switch to turn off. If the tailcap switch is double pressed quickly halfway, then the light will be in momentary strobe mode.

Charging
Cabela’s CTL Flashlights all include a lithium-ion battery with a micro-USB rechargeable design. Each light is also compatible with Lithium CR123A batteries (not included).
To charge your battery:

•  Locate the included Micro USB to USB type A charging cord.
•  Remove the battery from the flashlight.
•  Plug the Micro USB end of the cord into the USB type B port located on the end of the battery.
•  Now insert the USB type A end of the cord into a properly rated power source. Charging will begin immediately. There is an indicator light on the battery: Red means charging and Blue means fully charged. Depending on power source, charging may take up to 5 hours.

Note: It is highly recommended that you only charge the battery with the included cord. Do not use an adapter that will exceed 5V.

Tailcap charging

The 1000 and 1200 models have a direct-charge capability that will allow you to recharge the battery without removing it from the flashlight.

•  Locate the tailcap charge cord.
•  Pull back the rubber cover on the tailcap charge port. It is located next to the Tai leap switch.
• Insert the male end of the tailcap cord into the charge port on the tailcap of the flashlight. Plug the USB end of the cord into the power source. Charging will begin immediately. There is an indicator light on the tailcap: Blue flashing means charging. Blue solid means charged.
• There is a cutout on the tail cap that allows the ridges on the charge cord to lock into place. Untwist to remove once the light is charged.

Troubleshooting

• Check to ensure the battery is good and installed in the correct polarity. If you are not sure of the battery status, replace with new battery and retry.
•  Carefully inspect the light. Make sure the spring in the cap end is centered and comes in contact with the battery.

Battery Installation

•  Unscrew the cap end and remove from the unit.
• Replace old batteries with new lithium-ion rechargeable batteries or compatible CR123A batteries in the correct polarity.
• Replace cap end

Warning:
Cabela’s CTL Flashlights are high-output lighting devices that produce a substantial amount of heat during operation. Please read your owner’s manual on the flashlight and heed the following battery warnings.

• Always keep batteries away from children.

•  All batteries can explode, catch fire, and potentially cause injuries if punctured, cut, crushed, short-circuited, incinerated, disassembled, recharged (disposable batteries only), or exposed to water, fire, or extreme temperatures.

•  Follow directions in the owner’s manual for battery installation. Replace all batteries at the same time and do not load batteries in backward.

• Store loose batteries in a cool, dry, ventilated area that does not include hazardous or combustible materials.

• For best performance and product safety, replace depleted batteries with Cabela’s-brand batteries. It is highly recommended that any alternate brand replacement be a compatible, UL-certified battery.

•  Never attempt to recharge a disposable 123A lithium battery.

• Only recharge lithium-ion (and LFP 123A) rechargeable batteries with their manufacturer­

• Failure to follow any of these instructions could result in damage to your flashlight.

• Follow all applicable laws and regulations pertaining to the transport, shipping, and disposal of batteries. For details on recycling batteries, please contact a government recycling agency or local waste disposal service. You may also refer to:
  www.batteryrecycling.com

•  All performance claims are based upon the use of Cabela’s-brand batteries that ship with Cabela’s CTL Flashlights.

Maintenance

To keep your flashlight in good condition, wipe with a clean, dry cloth. If there is buildup, use a mild soap to clean, and then make sure to wipe the flashlight dry.
These flashlights have 0-rings to keep them clean and dry. In order to maintain the IPBX rating, frequently check your 0-ring for wear and replace if torn or broken. You can also maintain your light and 0-rings by occasionally applying lube.

Whether you made your purchase online, from a catalog, or in a Bass Pro Shops/Cabela’s store, you may return or exchange it by mail or at any of our stores. To return or exchange an item at one of our retail locations, please present a valid photo I.D., which will be recorded to authorize returns. Bass Pro Shops/Cabela reserves the right to address abuse of this policy and/or deny returns or exchanges. Other restrictions may apply. Please visit basspro.com or cabelas.com
Customer Service Information: 2500 East Kearney Springfield, MO 65898 1-800-227-7776

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>