SECURITY BRANDS 14-RK10 Ridge Reskey User Guide

June 6, 2024
SECURITY BRANDS

SECURITY BRANDS 14-RK10 Ridge Rickey

SECURITY-BRANDS-14-RK10-Ridge-Reskey

START TO HEAR

SECURITY-BRANDS-14-RK10-Ridge-Reskey-
FIG-1

  1. Unpack the box and make sure you have all items shown here. (Screwdriver not shown.)
  2. Remove single screw from the bottom of the unit and remove unit from mounting plate, pulling away from the bottom end.
  3. Remove screws from the back of unit housing and carefully remove back cover to get access to battery holders.
  4. Hold circuit board in place and insert batteries into battery holders, making sure to place incorrect orientation.
  5. Replace back cover of unit and secure with screws.
  6. Install mounting plate where desired (hardware not included). (Can be done after programming.)
  7. Attach unit and secure with screw. (Can be done after programming.)

433-MHz Programming

Pair Keypad Unit with Ridge 2.0 Receiver (14-REC20) On Ridge 2.0 Transceiver, press and hold the programming button for two seconds and let go.
LED will light. Perform procedure below, and LED will go out if pairing is successful.

300-MHz Programming

(For 300-MHz receivers including the Receiver 300 14-REC300)
IMPORTANT! For security reasons, we recommend using custom DIP switch positions.

Call 972-474-6390
Email techsupport@securitybrandsinc.com
We are available Mon–Fri / 8 am–5 pm Central

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

SECURITY BRANDS User Manuals

Related Manuals