SECURITY BRANDS 14R300 Wireless Access Control Archives Instructions
- June 6, 2024
- SECURITY BRANDS
Table of Contents
SECURITY
BRANDS
INSTRUCTIONS
REMOTE 300
Model 14-R300
**IN THE BOX
**
Make sure you have everything shown here.
NOTE: The CR2032 battery comes pre-installed.
WHAT’S WHAT
The Remote 300 has two programmable buttons and a status LED. Each button can be paired to a separate receiver or the same receiver.
**SETUP
**
-
On your 300-MHz receiver, set DIP switches to desired positions. NOTE: For best results, we recommend using the Security Brands Receiver 300 (14-REC300).
NOTE: By default, both sets of DIP switches on the Remote 300 are matched to the default DIP switch positions of the Receiver 300 and other 300-MHz receivers. For security reasons, we
recommend using custom DIP switch positions.
NOTE: Some DIP switches may be labeled differently. The position labeled 10 corresponds to the position labeled 0 on the remote, and the DIP switches on some receivers have the off position labeled as OPEN. -
Open Remote 300 unit by removing two screws on the bottom side and pulling case apart. Remove visor clip if needed for easier access.
NOTE: Make sure the circuit board stays attached to the base of the remote unit and does not come off with the cover. -
Find DIP switches on Remote 300 unit corresponding to the button you want to program.
NOTE: Pay attention to the markings on the circuit board showing which set of DIP switches corresponds to which button. -
Set DIP switches to match those set on the receiver.
DIP Switches on Remote 300 (default positions for both buttons)
Repeat the procedure for the second button if desired. Otherwise, close the unit and secure it with screws.
NOTE: The second button can be paired with the same or a different 300-MHz receiver.
HOW TO USE
- Make sure you are in the range of the 300-MHz receiver you want to control.
- Press the remote button linked to the desired receiver. The LED should light.
- The receiver will respond and operate the gate/door.
NOTE: If the receiver does not respond, make sure it has power and that the remote LED is lighting when a button is pressed. If not, check the battery. If the receiver still does not respond, make sure its antenna is not inside a metal box, the DIP switch positions match on both remote and receiver, and if it is a third-party receiver, make sure the frequency jumper is in the 300-MHz position.
Two-Year Limited Warranty
Visit securitybrandsinc.com/warranty/ for
details
WARNING! AUTOMATIC GATES CAN CAUSE SERIOUS INJURY OR DEATH!
ALWAYS CHECK THAT THE GATE PATH IS CLEAR BEFORE OPERATING!
REVERSING OR OTHER SAFETY DEVICES SHOULD ALWAYS BE USED!
NEED HELP
call 972-474-6390
or email
techsupport@securitybrandsinc.com
SECURITY BRANDS INC™
your partner in access control
© 2021 Security Brands, Inc. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>