SANUS BSA-IWP1 Cable Concealer Recessed Power Kit Instruction Manual
- June 17, 2024
- SANUS
Table of Contents
SANUS BSA-IWP1 Cable Concealer Recessed Power Kit
Product Information
Specifications:
- Product Name: Cable Concealer Recessed Power Kit
- Model: BSA-IWP1
- Maximum Length: Up to 6 feet
- Manufacturer: SANUS
- Contact Information: 1-800-359-5520, info@sanus.com
- Address: 6436 City West Parkway, Eden Prairie, MN 55344
Product Usage Instructions
Tools Needed:
- Stud Finder
- Drywall Saw
- Phillips Screwdriver
- Slotted Screwdriver
Installation Instructions:
- Locate desired locations between studs using a stud finder.
- Use a drywall saw to cut the template according to your desired measurements.
- Run power cord and A/V cables through the designated spaces.
- Secure the assembly by inserting it into the wall and locking the tabs with screws.
- Follow the assembly instructions provided in the manual for a proper installation.
- Connect the cables as instructed in the manual.
FAQ (Frequently Asked Questions)
-
Q: Can this product be used on circuits other than 15 amps?
A: No, this product is only intended for use on 15 amp branch circuits to avoid risks of fire and shock. -
Q: Can I install the power supply cord within the wall cavity?
A: No, it is important to avoid installing the power supply cord within the wall cavity to prevent fire hazards. -
Q: What should I do if I have doubts about the safety of installation?
A: If you are unsure about the safety of installing or using this product, please contact customer service for assistance.
Tools Needed
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ ENTIRE MANUAL PRIOR TO USE – SAVE THESE INSTRUCTIONS
Legrand electrical products conform to and should be properly grounded in compliance with requirements of the current National Electrical Code or codes administered by local authorities. All electrical products may present a possible electric shock or fire hazard if improperly installed or used. Legrand electrical products may bear the mark of a Nationally Recognized Testing Laboratory and should be installed in conformance with current local and/or the National Electrical Code.
- CAUTION: Avoid potential personal injuries and property damage!
- RISK OF FIRE AND SHOCK – Only intended for use on 15 amp branch circuits.
- RISK OF FIRE – DO NOT install power supply cord within the wall cavity.
- RISK OF FIRE AND SHOCK – DO NOT connect this box with any other circuits or outlets.
- Do not use this product for any purpose not explicitly specified by the manufacturer.
- The manufacturer is not responsible for damage or injury caused by incorrect assembly or use.
- If you do not understand these instructions or have doubts about the safety of the installation, assembly or use of this product, contact customer sevice.
INSTALLATION
Thank you for choosing SANUS!
Please take a moment to let us know how we did:
Legrand AV Inc. and its affiliated corporations and subsidiaries (collectively, “Legrand”), intend to make this manual accurate and complete. However, Legrand does not claim that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Legrand makes no representation or warranty, expressed or implied, regarding the information contained herein. Legrand assumes no responsibility for the accuracy, completeness or sufficiency of the information contained in this document.
1-800-359-5520
info@sanus.com
6436 City West Parkway, Eden Prairie, MN 55344
©2022 Legrand AV Inc. All Rights Reserved. Made in China.
©2022 Legrand AV Inc. Todos los derechos reservados. Hecho en China.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>