ATEN PE4104G NRGence IP Control Box User Guide

: June 6, 2024
: Aten

Table of Contents

ATEN PE4104G NRGence IP Control Box
Package Contents
Hardware Review
Mounting
Hardware Installation
Securing the Cables
Documents / Resources

ATEN PE4104G NRGence IP Control Box

Package Contents

1 IP Control Box
1 Standard Rack Mount Kit
1 Power Cord
4 Footpads
1 User Instructions

Hardware Review

LAN Port
Reset Button (recessed)
Sensor Port & LED
Door Sensor Dry-Contact Port
Power Control Buttons & LEDs
Device Power LED
Grounding Terminal
Power Outlet Sockets
Circuit Breaker
Power Inlet Socket

Mounting

Desktop Mount
If you wish to keep your unit on a desktop, attach the supplied footpads and place the unit on any appropriate level surface that can safely support its weight plus the weight of its attached cables.

Rack Mount

Decide where you would rack mount the unit and choose where you would attach the rack mount ear (Position 1, 2, 3 or 4). As an example, we will choose to attach the rack mount ear shown above (position 3).
Align and stabilize the rack mount ear using M3 Philips hex screws.
Align the unit and rack mount ear to the rack and stabilize using rack screws.
Let the buttons stabilize in the button holes and the mounting is complete.

Hardware Installation

Make sure the unit is properly grounded.
Note: Do not omit this step. Proper grounding helps to prevent damage to the unit from power surges or static electricity.
For each device you want to connect, connect its power cable to any available outlet on the unit. Optionally, use ATEN Lok-U-Plug cable holders to secure them (see above).
Connect an internet-enabled LAN cable into the unit’s LAN port.
(Optional) If you are to use an environmental sensor in your installation, connect it to the RJ-11 sensor port.
(Optional) If you are to use a door sensor in your installation, connect it to the Door Sensor Dry-Contact Port.
Use the power cord provided to connect the unit’s Power Inlet Socket to an AC power source.
Power on the connected devices.

Securing the Cables

For added safety, use ATEN Lok-U-Plug cable holders to secure the cables from your attached devices in place on the unit, refer to Hardware Installation step 2.
Note: Lok-U-Plug Cable Holders and their Installation Tools are optional and sold separately. For more information, please refer to the PE4104G user manual.

© Copyright 2021 ATEN® International Co., Ltd. ATEN and the ATEN logo are trademarks of ATEN International Co., Ltd. All rights reserved. All other trademarks are the property of their respective owners.

Support and Documentation Notice
All information, documentation, firmware, software utilities, and specifications contained in this package are subject to change without prior notification by the manufacturer. To reduce the environmental impact of our products, ATEN documentation and software can be found online at http://www.aten.com/download/
Technical Support
www.aten.com/support

Scan for more information