SHERPA 582040 Window Panel Rotopax Mount Kit Instruction Manual

October 27, 2023
SHERPA

Sherpa logo

WINDOW PANEL

ROTOPAX MOUNT

INSTALL INSTRUCTIONS

R E V. 1

HARDWARE CHECKLIST

Exact hardware color counts may vary based on the options selected at checkout.


4 Vibration dampers          4 1/4″-20 Hex bolt (5/8″)

4 1/4″-20 Nylock nut        4 1/4″ Washer

Before you start

It is suggested that all accessories are installed while the window panel is off of the vehicle. This makes the process of positioning and fastening the accessory much easier.

Setup

Required Components:

4x Rotopax carriage bolts
4x Rotopax flat washers
4x Rotopax nylock nuts
1x Rotopax Standard/DLX/LOX

If the bottom mounting plate supplied with all standard/DLX/LOX Rotopax mounts is not already installed, do so using the 2x M8 x 12mm bolts supplied by Rotopax.

SHERPA 582040 Window Panel Rotopax Mount Kit A01

SHERPA 582040 Window Panel Rotopax Mount Kit A02

Assembly 01

Required Components:

4x 1/4″-20 x 5/8″ Hex bolt
4x 1/4″ Flat Washers
4x Nylock nuts

Secure the rotopax assembly to the window panel using the supplied hex bolts, nuts, and flat washers. Each bolt should sit at the ends of the X-pattern on the window panel. Note that the bolts should be run through the back side of the panel so that the excess threads point away from the glass. This is important for maximizing the clearance between the window panel components and the window.

SHERPA 582040 Window Panel Rotopax Mount Kit A03

SHERPA 582040 Window Panel Rotopax Mount Kit A04

Assembly 02

Slide the Rotopax container over the base and screw the supplied handle in to secure the Rotopax container.

SHERPA 582040 Window Panel Rotopax Mount Kit A05

Assembly 03

Once the Rotopax container is situated, lift it back off of the panel slightly and install the supplied vibration dampening plugs through the slots in the four corners of contact between the container and the panel.

SHERPA 582040 Window Panel Rotopax Mount Kit A06 SHERPA 582040 Window Panel Rotopax Mount Kit A07

Assembly 04

Repeat the installation process in the two outer Rotopax mounting locations on the panel if you plan to use 2x 2 gallon containers, or 1x 4 gallon container.

SHERPA 582040 Window Panel Rotopax Mount Kit A08

EXPLORE.

All products built and designed by Sherpa Equipment Company are intended for off-road use and should be assembled, installed, and used according to Sherpa Equipment Company’s recommendations. Sherpa Equipment Companies products should be used safely with good judgment towards others and surroundings.

By installing Sherpa Equipment Companies products on your vehicle you assume all liability. Sherpa Equipment Company will not be held liable for damages or loss associated with the installation or use of its products. It is recommended that you inspect your roof rack within the first 100 miles of installation and every 500 miles after.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals