SHERPA 253040 Antenna Mount Instruction Manual
- June 3, 2024
- SHERPA
Table of Contents
SHERPA 253040 Antenna Mount
HARDWARE CHECKLIST
Exact hardware color counts may vary based on the options selected at checkout.
BEFORE YOU BEGIN
Install the antenna mount in the configuration that best suits your needs!
These instructions will outline the general process of installing it, but that
process can be applied across a variety of different positions and
orientations.
USING TNUTS
Required Components:
- 1 Sherpa Antenna Mount
- 2 1/4”- 20, 1/2” bolt
- 2 1/4”- 20, Tnut
2 1/4” flat washer
Insert two Tnuts into the side slot of a cross member. The supplied bolt and
washer combination is then used to secure the antenna mount to the cross
member, as pictured.
The antenna bracket can also be mounted on the side of the sideplate in the
same slots that the crossmembers use if alternative hardware is used (not
included).
While specific models may vary, most antennas will come in two parts – the main antenna body with threads on the end, and a wiring harness end that has internal threads. Simply screw the main antenna body into the bottom while sandwiching the Sherpa Antenna Mount between them.
EXPLORE
All products built and designed by Sherpa Equipment Company are intended for
off-road use and should be assembled, installed, and used according to Sherpa
Equipment Company’s recommendations. Sherpa Equipment Companies products
should be used safely with good judgment towards others and surroundings.
By installing Sherpa Equipment Companies products on your vehicle you assume
all liability. Sherpa Equipment Company will not be held liable for damages or
loss associated with the installation or use of its products. It is
recommended that you inspect your roof rack within the first 100 miles of
installation and every 500 miles after.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>