OPTONICA 6341 10-Key RF Remote Controller User Guide
- June 6, 2024
- OPTONICA
Table of Contents
**OPTONICA 6341 10-Key RF Remote Controller User Guide
**
Safety information
- Read all instructions carefully before you begin this installation.
- When installing battery, pay attention to the battery positive and negative polarity. A long time without the remote control, remove the battery. When remote distance becomes smaller and insensitive, replace the battery.
- If no response from the receiver, please re-match the remote.
- Gently handle remote, beware of falling.
- For indoor and dry location use only.
Features
- Apply to single color or dual color LED controller.
- Each remote can match one or more receiver.
- R bC 2032 attery powered.
- Operate with LED indicator light.
- Magnet on the back which can be easily stuck on back holder or any metal surfaces.
Technical Parameters
Input and Output
Output signal| RF(2.4GHz)
Working voltage| 3VDC(CR2032)
Working current| ＜5mA
Standby current| ＜2μA
Standby time| 2 years
Remote distance| 30m
Safety and EMC
EMC standard (EMC)| EN301 489,EN 62479
Safety standard(LVD)| EN60950
Radio Equipment(RED)| EN300 328
Certification| CE,EMC,LVD,RED
Environment
Operation temperature| Ta: -30 OC ~ +55 OC
Case temperature (Max.)| T c: +85OC
IP rating| IP20
Mechanical Structures and Installations
To fix the remote, three options are offered for selection:
Option 1: stuck the remote on any metal surfaces directly.
Option 2: fix the remote’ back holder on the wall with two screws.
Option 3: adhere the remote’ back holder to the wall with paster.
Match Remote Control (two match ways)
End user can choose the suitable match/delete ways. Two options are offered for selection:
Use the controller’s Match key
Match:
Short press match key, immediately press on/off key (single zone remote) or
zone key (multiple zone remote) of the remote.
Delete:
Press and hold match key for 5s to delete all match, The light blinks 5 times
means all matched remotes were deleted.
Use Power Restart
Match:
Switch off the power, then switch on power again, immediately short press
on/off key (single zone remote) or zone key (multiple zone remote) 3 times on
the remote. The light blinks 3 times means match is successful.
Delete:
Switch off the power, then switch on power again, immediately short press
on/off key (single zone remote) or zone key (multiple zone remote) 5 times on
the remote. The light blinks 5 times means all matched remotes were deleted.
Key function
4 zone dimming remote
All on: Turn on all 4 zone light.
All off: Turn off all 4 zone light.
Zone 1 4 on – :
Short press turn on zone light, long press 1-6s increase brightness
continuously.
Zone 1 4 off – :
Short press turn off zone light, long press 1-6s decrease brightness
continuously.
Warranty
Warranty 3 years
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>