Stadler Form A-030 Anna Little Heater Instruction Manual

June 6, 2024
Stadler Form

Stadler Form A-030 Anna Little Heater

Stadler Form A-030 Anna Little Heater-fig3

Intoduction

Congratulations! You have just purchased the exceptional ANNA / ANNA little fan heater. It will bring you great pleasure and improve the ambient air for you. As with all domestic electrical appliances, particular care is needed with this model also, in order to avoid injury, fire damage or damage to the appliance. Please study these operating instructions carefully before using the appliance for the first time and follow the safety advice on the appliance itself.

Description of the appliance

The appliance consists of the following main components

  1. Housing
  2. On/Off button
  3. Output button
  4. Thermostat
  5.  Front cover
  6. LED light
  7. Removable and washable filter
  8. Back cover
  9. Cable
  10. Foot

Important safety instructions

Please read through the operating instructions carefully before you use the appliance for the first time and keep them safely for later reference; if necessary pass them on to the next owner.

  • THIS PRODUCT IS ONLY SUITABLE FOR WELL INSULATED SPACES OR OCCASIONAL USE.
  • CAUTION – Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
  • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
  • Children of less than 3 years should be kept away unless continuously supervised.
  • Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given super-vision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
  •  If the supply cord is damaged, it must be replaced by the manufacturer, or its service agent, or a qualified person in order to avoid a hazard.
  • Stadler Form refuses all liability for loss or damage which arises as a result of failure to follow these operating instructions.
  • The appliance is only to be used in the home for the purposes described in these instructions. Unauthorised use and technical modifications to the appliance can lead to danger to life and health.
  • Never submerge the unit in water (danger of short circuiting).
  • Never run a defective unit (e.g. supply cord).
  • Never touch energized parts.
  • Only connect the cable to alternating current. Observe the voltage infor-mation given on the appliance. Do not use extension cords.
  • The heater must not be located directly below a socket-outlet.
  • Do not open the appliance (repairs only by service agents).
  • Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool (the appliance is not splash-proof).
  • Do not run the power cord over sharp edges and make sure that it does not get trapped. Do not pull the plug from the socket with wet hands or by holding on to the power cord.
  • Do not place the appliance near a heat source. Do not subject the power cord to direct heat (such as a heated hotplate, open flames, hot iron sole plates or heaters for example). Protect power cords from oil.
  • Please make sure that the used socket remains accessible.
  • Do not run the heater on an uneven or soft surface.
  • CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer.
  • WARNING: In order to avoid overheating, do not cover the air inlet or air outlet – fire hazard!
  • Do not use the heater in small rooms (below 4 m2 in size), in explosive envi-ronnment, or for drying laundry.
  • Do not touch the front grille, it might reach hot temperature.
  • Use the heater only under supervision.
  • Do not insert any object and/or finger into the openings of the heater.
  • To extinguish burning appliances only use fire blankets.
  • For indoor use only.

Setting up / operation

  1. Having set up the Anna heater in the desired position connect the cable (9) to the household supply socket.
  2. Switch on Anna by clicking the on/off button (2)
  3. Using the output button (3), you can control the heating output of Anna:
  4.  Button in = 2’000 W (Anna) / 1’200 W (Anna little)
  5.  Button out = 1’200 W (Anna) / 900 W (Anna little)
  6. Room thermostat (4): The room thermostat control allows a variable temperature adjustment. Setting: for maximum temperature turn to the left (sun symbol), for minimum temperature, turn the control to the right (cold symbol).
  7. Recommendation: Turn the thermostat control to the left to the maximum. If the desired room temperature has been reached, turn the thermostat control to the right until the appliance switches off. If the room temperature drops, then Anna switches on again automatically. Please note that after the thermostat switches off automatically, it takes a few minutes for the heater to switch on again!5. Protection against overheating: Anna is fitted with an over-temperature safety device that switches off the appliance in the case of a technical fault or improper use. Should this occur, pull the mains cable (9) out of the supply socket and remedy the fault or correct the method of use. The appliance can be put back into use when it has cooled down and has been disconnected from the main supply for a short time.
  8. In the first few hours after putting Anna into operation, there might be an unpleasant smell. This smell will dissipate and it is nothing to worry about. Tip: At the back of Anna you can find the air inlet. The air inlet is covered with an air filter and a grid. The grid is detachable. Please take off the grid and remove the air filter. You may wash out the air filter with a little bit of soap and warm water. Rinse it well and let it dry completely before you put it back on the air inlet and reattach the grid.

Note: Make sure that there is always sufficient space between the appliance and the wall or other large objects (> 50 cm). The air flow must not be blocked by objects of any kind.

Stadler Form A-030 Anna Little Heater-fig4

Cleaning

Before servicing the heater and after each occasion of use, switch off the appliance and unplug the mains cable from the socket.

  • Attention: Never immerse the appliance in water (danger of short- circuit).
  •  To clean the appliance, only wipe it down with a damp cloth and then dry it carefully.
  • If the filter (7) behind the back cover is full of dust, please remove the filter, wash it or clean it with the vacuum cleaner.

Repairs

  • Repairs to electrical appliances must only be carried out by a qualified electrical technician. If improper repairs are carried out, the warranty lapses and all liability is refused.
  • Never operate the appliance if the adaptor or plug is damaged, after it has malfunctioned, if it has been dropped or has been damaged in any other way (cracks/breaks in the casing).
  • Do not push any object into the appliance.
  • If the appliance is beyond repair, make it unusable immediately by cutting through the cable and handing it in at the collection point provided for the purpose.

Specifications

  • Rated voltage 220 – 240 V
  • Power output Anna 2’000 W, Anna little 1’200 W
  • Dimensions Anna 183 x 367 x 150 mm
  • Anna little 183 x 237 x 150 mm
  • (width x height x depth)
  • Weight Anna 2.05 kg, Anna little 1.5 kg
  • Sound level Anna < 43 dB(A), Anna little < 47 dB(A)
  • Complies with EU regulations CE / WEEE / RoHS/ EAC

Name| Manufacturer / Trade Mark| Type / Model| Technical Data
---|---|---|---
heater for Anna| Dongguan Long Yang Electronic Technology Co., Ltd| 2000 W| 230 V, 50 / 60 Hz

2000 W

heater for Anna little| Dongguan Long Yang Electronic Technology Co., Ltd|


1200 W

| 230 V, 50 / 60 Hz

1200 W


fan motor

| ****

Shenzhen Jiangshanlai Electronics Science Co., Ltd

| ****

JDH1225S

| DC 12 V

2000 rpm

3.6 W Class 120

Item Symbol Value Unit

Heat output (Anna / Anna little)
Nominal heat output| Pnom| 2 / 1.2| kW
Minimum heat ouput (indicative)| Pmin| 1.2 / 0.9| kW
Maximum continous heat output| Pmax,c| 2 / 1.2| kW
Auxillary electricity consumption
at nominal heat output| elmax| 0.0072 / 0.0036| kW
at minimum heat output| elmin| 0.0072 / 0.0036| kW
in standby mode| elSB| 0 / 0| kW

Item Unit

Type of heat input
manual heat charge control,with integrated thermostat| [no]
manual heat charge control with room and / or outdoor temperature feedback| [no]
electronics heat charge control with room and / or outdoor temperature feedback| [no]
fan assisted heat output| [no]
Type of heat output / room temperature control
single stage heat output and no room temperature control| [no]
Two or more manual stages, no room temperature control| [no]
with mechanic thermostat room tenperature control| [yes]
with electronic room temperature control| [no]
electronic room temperature control plus day timer| [no]
electronic room temperature control plus week timer| [no]
Other control options
room temperature control, with presence detection| [no]
room temperature control, with open window detection| [no]
with distance control option| [no]
with adaptive start control| [no]
with working time limitation| [no]
with black bulb sensor| [no]
Contact details| Stadler Form Aktiengesellschaft Chamerstrasse 174, 6300 Zug, Switzerland

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals