Conquer Industry CQL1806-B Wireless Diffuser Speaker Instruction Manual
- June 6, 2024
- Conquer Industry
Table of Contents
Industry CQL1806-B Wireless Diffuser Speaker
Instruction Manual
Power:
- Insert the small connector of the supplied micro-USB power cable into the USB power port on the back of the speaker.
- Insert the large connector into the USB port on a computer or a 5V USB adapter (not included) and plug into a wall socket
- The LED indicator will turn red when the speaker is connected to a power source.
- LED Power Indicator
- Fan/LED power Switch
- Bluetooth Power Switch
Playing Music via Bluetooth
- Turn your Bluetooth speaker on by sliding the power switch located on the back of the speaker to the ON position to activate the Bluetooth function.
- A tone will be heard to indicate the speaker entering pairing mode and searching for your Bluetooth device.
- Make sure the Bluetooth function on your device is turned on.
- Search the speaker named ”XXX”.
- Once you have selected the speaker, your device will pair without a password. (If your device prompts for a password, enter the password”0000”.)
- Start playing music on your device. Make sure that you keep your device within a 33 feet range of your Bluetooth speaker.
- Adjust the volume of your device to a comfortable level.
- Turn off the unit when not in use.
Light Operation
- Push the Fan/LED power switch to the “ON” position
- The LED light will light up and cycle through different colors automatically
- Turn the Fan/LED switch to the “OFF” position to turn off the light
Using as A Diffuser
- Remove the cover from the top
- Place a few drops of essential oil onto one of the included scent pads
- Place the scent pad on the platform inside the unit
- Push the Fan/LED power switch to the “ON” position to turn on the fan.
- Turn the Fan/LED switch to the “OFF” position to turn off the fan while not in use
Caution:
- This is not a toy. Please keep away from children.
- Low power may cause poor connection even no working of Bluetooth.
- Do not overcharge the battery.
- The battery pack shall not be exposed to excessive heat such as sunshine, fire or the like.
FCC/ISEDC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>