CONQUER INDUSTRY CQL1806-B Diffuser LED Bluetooth Speaker Instruction Manual
- October 29, 2023
- Conquer Industry
Table of Contents
CONQUER INDUSTRY CQL1806-B Diffuser LED Bluetooth Speaker
Power
- Insert the small connector of the supplied micro-USB power cable into the USB power port on the back of the speaker.
- Insert the large connector into the USB port on a computer or a 5V USB adapter (not included) and plug into a wall socket
- The LED indicator will turn red when the speaker is connected to a power source.
- LED Power Indicator
- Fan/LED Power Switch
- Bluetooth Power Switch
Playing Music via Bluetooth
- Turn your Bluetooth speaker on by sliding the power switch located on the back of the speaker to the ON position to activate the Bluetooth function.
- A tone will be heard to indicate the speaker entering pairing mode and searching for your Bluetooth device.
- Make sure the Bluetooth function on your device is turned on.
- Search for the speaker named ”XXX”.
- Once you have selected the speaker, your device will pair without a password. (If your device prompts for a password, enter the password”0000”.)
- Start playing music on your device. Make sure that you keep your device within a 33 feet range of your Bluetooth speaker.
- Adjust the volume of your device to a comfortable level.
- Turn off the unit when not in use.
Light Operation
- Push the Fan/LED power switch to the “ON” position
- The LED light will light up and cycle through different colors automatically
- Turn the Fan/LED switch to the “OFF” position to turn off the light
Using as A Diffuser
- Remove the cover from the top
- Place a few drops of essential oil onto one of the included scent pads
- Place the scent pad on the platform inside the unit
- Push the Fan/LED power switch to the “ON” position to turn on the fan.
- Turn the Fan/LED switch to the “OFF” position to turn off the fan while not in use
Caution:
- This is not a toy. Please keep away from children.
- Please keep away from water/heat.
- Low power may cause poor connection even not working of Bluetooth.
- Do not overcharge the battery.
- Battery packs shall not be exposed to excessive heat such as sunshine, fire, or the like.
FCC STATEMENT WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with a minimum 20cm distance between the radiator and your body: Use only the supplied antenna.