Conquer Industry CQL1878-B Bluetooth Speaker Instruction Manual
- June 5, 2024
- Conquer Industry
Table of Contents
Conquer Industry CQL1878-B Bluetooth Speaker
Power:
-
Works on internal rechargeable Lithium battery. Please charge your speaker fully before first use. To charge the battery :
Using a Micro USB cable (included), insert the jack into the ”Charging” hole on the back of unit under the silicone cover , then plug the USB connector in to the USB port on a computer for charging. -
A red light will indicate the charging situation. When battery is full, the red light will turn off automatically.
Setting Up: Remove liner from glass, then insert glass tab into speaker base.
Bluetooth Speaker Operation
- Turn on the unit by pushing the switch to “ON” position. The LED light on top will light on indicate the speaker is in paring mode and searching for your Bluetooth mobile device.
- Open the Bluetooth function on your device and search the speaker named “XXX”. After selecting this speaker, your device will pair without a password. (If required, enter the password “0000” to finalize the paring).The Blue light will begin to flash slowly after pair is complete.
- Start playing music on your device. Keep your device within 33feet (10 meters) of your speaker.
- Adjust the volume of your device to a comfortable level.
- Control play/pause, volume up/next track and volume down/previous track either on your connected device or by the buttons on the fabric of the speaker.
- Turn off the unit when not in use.
Light Operation
- Push the On Off button to the “On” position to turn on the unit, the light will light up automatically.
- Play music on your mobile device, the light will dance to the music.
- Turn off the unit , the light will turn off accordingly.
Caution:
- This is not a toy. Please keep away from small children.
- Please keep away from water / heat.
- Low power may cause poor connection even no working of Bluetooth.
- Do not over charge the battery.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>