FALCON RIDGE Kawasaki Teryx4 Soft Top Instruction Manual

: June 3, 2024
: FALCON RIDGE

Table of Contents

FALCON RIDGE Kawasaki Teryx4 Soft Top
Return Policy
Warranty
Documents / Resources

FALCON RIDGE Kawasaki Teryx4 Soft Top

FALCON-RIDGE-Kawasaki-Teryx4-Soft-Top-product

Notice: Do not smoke inside the cab or expose the enclosure to direct flames. The cab is Flammable.

Be sure to read these instructions thoroughly before opening and installing the Kawasaki 16Teryx 4 Top Cap. The installation is best done when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions prevent installing in warmer weather it helps to store the adhesive Velcro at room temp. Prior to installation.
Carefully open the carton and remove the rolled Top Cap on a large flat surface that is clean and free of dirt.
Check over the parts included in the carton with the parts list shown below:

Adhesive Hook strips: 7 each 6” long
Webbing straps with Velcro: 4 each
Webbing straps with Grommet: 2 each
Top Cap: 1 each

Place the Top Cap over the roll cage of the Teryx 4. Down the front and rear of the roll cage, you must wrap the bar with one of the adhesive hook strips roughly 6-10” from where the top is. Wrap the double-sided Velcro sewn to the ends of the webbing straps around the adhesive hook strips so that the webbing strap is pointing up towards the top.
Next, take the straps and lace them through the buckles sewn to the corners of the Top Cap as shown in the diagram below

Next, wrap the roll cage with the Double-Sided Velcro strip with a snap around the middle bar to match up with the snap on the Top Cap. Install the double-sided Velcro with a snap the same as above. Then snap the two together as shown in the photos below.

Cleaning and Storage Recommendations:

Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll it for storage.
It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at normal room temperature. It is best not to expose the Cab to either extremely hot or cold temperatures when storing.
A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if the additional hook and loop sets are needed, they can also be ordered.

Return Policy

If for any reason you choose to return this product it must be returned within 30 days from the date the item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product! The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows. All returned products will be inspected upon arrival at the production facility and must be in unused, factory-new condition to receive a refund – a 25% restocking fee will apply. If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridges’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory-new condition. NOTE: All windshields must be returned with the original protective film intact and not removed. Do NOT REMOVE it if you have any intentions of returning the item. Refund/ replacement of a windshield will only be processed on items with original protective film or if the windshield is defective. Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh, and in new resalable condition (any returned items that have been used, altered, or damaged in any way will not be subject to a refund.) All contents including instruction manuals, accessories, hardware, Velcro, etc. must be included in your return shipment. Only items in OEM factory new condition will be approved. Once returned items are received, a credit will be issued to the original credit card/ payment method used for the purchase. Outbound shipping and return shipping costs will not be refunded. Please allow 4 to 6 weeks for your refund to be processed.

Warranty

To The Owner of this Product:
Thank you for purchasing one of Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops, and/or windshield due to defects in the product. Please refer to the return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.