FALCON RIDGE Polaris RZR PRO XP AeroVent Windshield Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE Polaris RZR PRO XP AeroVent Windshield
Instructions for Installation and Care of Polaris RZR PRO XP Aero-Vent Lexan
Windshield
PO-RZR-PROXP-WD05
NOTICE: Please check contents of package for any damage and make sure all
parts fit correctly and you are happy with the product before removing
protective film. Once the film is removed you cannot return the product for a
full refund.
Instructions Installation
-
Be sure to read these instructions thoroughly before opening and installing the Polaris RZR Lexan Windshield.
-
Check over the parts included in the cartons with the parts list shown below: Strap Clamps 6 each
-
1 ¾” Hex Head Bolts 2 each
-
Lock Nuts 2 each
-
Nylon Spacers 4 each
-
Plastic Slide Fasteners 12 each
-
36” End Bulb Gasket 1 each
-
1/2″ wide Adhesive Padding 36″ Long
-
Vent Slider 2 each
-
Windshield 1 each
-
Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by peeling off the protective film. Next take the 36 ” piece of rubber gasket and starting at one end firmly place across the bottom of the windshield. You may need to trim any excess.
-
Next prepare the vent slider to be installed on the windshield. Take the two hex head bolts, 4 nylon spacers and two lock nuts and attach them to the vent sliders as shown in the photos below.
Take the spacers and slide two of them over the bolt as shown below
Now insert the bolt in the small holes and screw on the lock nuts so the end of the bolt is flush with the outside edge of the lock nut. Make sure that you place the bolt through hole on each slider so that they are mirror images of each other. -
Now place the sliders on the inside surface of the windshield. The ends of the sliders with the point should be facing away from the center of the windshield. And place the plastic slide fasteners through the slots on the slider and into the holes in the windshield. The lock nuts should be in the large slots of the windshield
-
You are now ready to install the windshield on your roll cage. Place the windshield on the vehicle first. Making sure that the bottom of the windshield overlaps the top edge of the hood to reach the bottom hood section as shown in the photo below.
-
Then take the six Velcro clamps and place them through the square holes then wrap the strap around the roll cage and under the wire as shown in the photo below.
-
Then just Pull the strap back around the bar and attach it to the Velcro.
-
Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of some sort to decrease the chance of scratches. We recommend using microfiber cloths that are readily available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag or micro-fiber cloth to clean it.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>