FALCON RIDGE KAW-610-HT01 Kawasaki Mule 610 Diamond Plate Top Instructions
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE KAW-610-HT01 Kawasaki Mule 610 Diamond Plate Top
Instructions for Installation and Care of Kawasaki Mule 600/610 Aluminum Diamond Plate Roof KAW-610-HT01
- Be sure to read these instructions thoroughly before opening and installing the Big Iron Roof.
- Check over the parts included in the cartons with the parts list shown below:
- 1 ¾” Loom Clamps: 4 each
- 1” Stainless Steels Bolts: 8 each
- Large Washers: 8 each
- Small Washers: 8 each
- Rubber Washers: 8 each
- Lock Nuts: 8 each
- 66” Rubber Edge Trim: 1 each
- Begin by taking the 4 loom clamps and wrapping 2 of them around the roll cage on both the front and back of the vehicle. Wrap them so that the flat side of the clamp is on top as shown in the photo below.
- Before placing the roof on the vehicle take the 66” Rubber Edge Trim and place it around the front edge as shown in the photo below.
- Run the edge trim from the channel on one side around to the channel on the other. See photo below.
- Now install the hardware as shown in the photo below. Do not tighten completely.
- If you have a Falcon Ridge Windshield the two pieces are made to connect together using bolts. We suggest bolting the roof to the windshield before tightening down the clamps above. The photo below shows how the two pieces should be connected.
- Make sure that the top and windshield are straight with each other. The bolt should fit in the middle of the slot on the roof. When together they should look like the photo below.
- Now tighten the clamps holding the roof down and the installation in complete. The following photos show how everything should look.(610 Roof not shown)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>