Bbpos Toast Direct Attached TB200 / CHB2J User Manual
- June 5, 2024
- bbpos
Table of Contents
Toast Direct Attached (TB200 / CHB2J) Instruction Manual
Follow your application instruction to start the transaction process, then
swipe, insert or tap the card to complete the transaction.
** If you pay via inserting an EMV IC card, please ensure that the EMV chip of
the card is facing the right direction. If you pay using an NFC card, please
ensure you tap the NFC payment card within a 4cm range on top of the NFC
marking.
NFC Status Indictors
Cautions & Important Notes
- Ensure the device is fully charged before use.
- Please ensure the EMV chip of the card is facing the right direction when inserting the card.
- The NFC card should be tapped within a 4 cm range on top of the reader mark.
- Don’t drop, disassemble, tear, open, crush, bend, deform, puncture, shred, microwave, incinerate, paint or insert a foreign object into the device. Doing any of this will damage the device and void the Warranty.
- Don’t immerse the device into water and place it near washbasins or any wet locations. Don’t spill food or liquid on the devices. Don’t attempt to dry the device with external heat sources, such as a microwave or hairdryer. Don’t use any corrosive solvent or water to clean the device.
- Recommend using a dry cloth to clean the surface only.
- Don’t use any sharp tools to point the internal components, connectors, or contacts, which may lead to devise malfunction and void the Warranty simultaneously.
Product Specifications
Functions| • EMV chip card reader (ISO 7816 compliant class A, B, C card)
• NFC Card Reader (EMV contactless, ISO 14443A/B)
• Over-the-air firmware update
• Over-the-air key update
---|---
Charging| Via micro USB
LED Indicator| All LEDs off – button release to power down Red LED on the –
device starting up / Charging battery Red LED off – fully charged Red LED
flashing – low battery /Critical low battery
NFC LED Indicator| Connecting with POS terminal – First LED flashing Ready for
NFC Reading – First LED on
Success Reading – 4 LEDs on in consecutive order Transaction Completed – One “BEEP” sound Errors – Two “BEEP” sound Power off – All LEDs off
Key Management| DUKAT, MK/SK
Encryption Algorithm| IDES
Support Operating System| Android 2.1 or above iOS 6.0 or above
Windows Phone 8 MS-Windows
Operating Temperature| 0°C – 45°C (32°F – 113°F)
Operating Humidity| Max 95%
Storage Temperature|
-20°C – 55°C (-4°F – 131°F)
Storage Humidity| Max 95%
FCC Caution Statement
FCC Supplier’s Declaration of Conformity:
BBPOS / TD200 (TD200W.TB200.TB200W.CHB25.CHB26.CHB2C.CHB2D.CHB2H.CHB2J)
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
BBPOS Corp.
970 Reserve Drive, Suite 132 Roseville, CA 95678
www.bbpos.com
Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator and any part of your body.
The user shall use the supplied USB cable if an available port open on the product
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>