nedis EXSOC415UFWT Extension Socket User Guide
- June 5, 2024
- nedis
Table of Contents
nedis EXSOC415UFWT Extension Socket
Extension Socket
Intended use
This product is intended to extend and multiply a single power outlet into
four power sockets and two USB ports.
The product is intended for indoor use only.
Any modification of the product may have consequences for safety, warranty and
proper functioning.
Specifications
| Product | Extension Socket |
|---|---|
| Article number | EXSOC415UFWT |
| Cable length | 1.5 m |
Specifications (Power sockets)
| Input power | 250 V / 16 A |
|---|---|
| Electrical class | I |
| Nominal power | Max. 3680 W |
| IP rating | IP20 |
Specifications (USB ports)
| Input power | 230 V ~ 50 Hz |
|---|---|
| Output voltage | 5 A |
| Output current | 2.1 V |
| Output power | 10.5 W |
| --- | --- |
| Average operation efficiency | 79.19 % |
| Efficiency at low load (10 %) | 73.76 % |
| No-load power consumption | 0.08 W |
Main parts (image A)
- Power socket
- USB ports
- Box
- Power plug
- Mounting bracket
- Mounting plate
- Screw
Safety instructions
WARNING
- Ensure you have fully read and understood the instructions in this document before you install or use the product. Keep the packaging and this document for future reference.
- Only use the product as described in this document.
- Do not use the product if a part is damaged or defective. Replace a damaged or defective product immediately.
- Do not cover the product.
- Do not drop the product and avoid bumping.
- Do not expose the product to water or moisture.
- Always check that the voltage of the product corresponds to the mains voltage.
- Disconnect the product from the power source and other equipment if problems occur.
- Do not plug or unplug the power cable with wet hands.
- Do not unplug the product by pulling on the cable. Always grasp the plug and pull.
- Unplug the product from the power source and other equipment if problems occur.
- This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.
Installing the product (image B)
It is optional to fasten the product to a table.
-
Fasten the product in a range of 1.5 meter from the power outlet.
- Place the mounting bracket A5 and mounting plates A6 on the table.
- Fasten A5 on the table with A6 and the screws A7.
- Slide the box A3 inside A5.
-
The product can be fastened in multiple ways.
-
To slide A3 out of A5, pull the legs of A5 slightly outwards.
Using the product -
Only plug the cable into a wall outlet. Do not use extension cords.
- Plug the product into a power outlet.
- Plug the desired cables into the power sockets and/or USB ports of the box.
For more information see the extended manual online: ned.is/exsoc415ufwt
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>