CHUANGO WI-210 Wireless Water Detector User Manual
- June 5, 2024
- CHUANGO
Table of Contents
CHUANGO WI-210 Wireless Water Detector
Introduction
This is a contact wireless water detector, which works based on the theory of liquid conductivity. The performance is reliable and the installation is easy. When the liquid reaches to the two probes of the detector, it will send wireless signal to the control panel. It can be widely used in computer rooms, warehouses and any places need to be protected from water. Two pieces of AAA 1.5V LR03 batteries are included in the detector, which enables 12 months standby
Product Overview
LED Indication
Flash once: Liquid is detected, sending wireless signal to the control panel.
Flash once every two seconds: Low battery. Please replace the battery
immediately.
PCB Layout
Connect to the Control Panel
Make sure the control panel is under learning status, then simulate an alarm case by touching the probe of detector with the water. When an alarm signal is received by panel, one beep is heard, indicating a successful connection.
Installation
- Remove the insulated strip, the detector will enter working mode.
- Use screw to fix the probe horizontally on the detection site.
- Use double-sided adhesive tape to fix the transmitter on the place where the liquid is normally unable to reach, and keep the antenna upward.
Change Batteries
Open the back case with screwdriver, and replace the batteries with new ones
according to the positive and negative marks.
Specifications
| Power supply: | DC 3 V (AAA 1.5 V LR03 x 2 PCS) |
|---|---|
| Static current: | < 29 uA |
| Alarm current: | < 23 mA |
| Transmitting distance: | < 80 m (in open area) |
| Radio frequency | 433.92 MHz |
| Housing material: | ABS plastic |
| Operating condition: | Temperature: -20 °C ~ +55 °C Relative humidity: < 80% |
(non-condensing)
Detector dimensions (L x W x H):| 54 x 14.5 x 107 mm
Probe dimensions (L x W x H):| 35 x 30 x 15 mm
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>