CHUANGO DWC-102 Wireless Door Window Contact User Manual
- June 4, 2024
- CHUANGO
Table of Contents
Wireless Door/Window Contact
DWC-102
User Manual
Introduction
The DWC-102 is a Door/Window Contact that can be installed on doors, windows,
and any other objects that open and close. The sensor transmits signals to the
control panel when a magnet mounted near the sensor is moved away. It will
also transmit an alert signal to the control panel in case of a low battery.
External input for wired accessories is available at the N/C interface. The
tamper protection ensures that sabotage attempts to move the contact will
result in alarm activation.
Product Overview
Power supply | DC 3V (AAA 1.5V LR03 Battery x 2 pc) |
---|---|
Static current | 23uA |
Transmitting distance | 801–n (in open area) |
Radio frequency | 433.92MHz |
Housing material | ABS plastic |
Operating temperature | 0°C- +50°C |
Relative humidity | 80% (non-condensing) |
Transmitter dimensions (LxWxH) | 107 x 54 x 14.5mm |
Magnet dimensions (LxWxH) | 49 x 19.4 x 9.6mm |
PCB Layout
NOTE: Tamper will be triggered no matter whether the door/window
contact is armed or disarmed.
**LED Indication
**
LED flashes once: The door/window is opened and the transmitter sends a
signal to the control panel.
Flash once per 3 seconds: Low power indication, please change the battery
as soon as possible. (User will get alert SMS about the low battery if the
door contact is connected to the GSM alarm system.)
Installation & Notice
- Open the case and remove the battery activation strip.
- Mount the sensor on the door frame and the magnet on the door.
- Make sure the magnet is on the right side of the transmitter
- Place the transmitter in the desired location, mount the magnet no more than 1cm away from the transmitter, and secure the transmitter and magnet with double-sided tapes or screws.
- Avoid mounting sensors in areas with a large quantity of metal or electrical wirings, such as a furnace or utility room.
FCC STATEMENT
-
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. -
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment..
Ver: DWC-102-EN-1405-V5.0
© 2014 Chuango. All rights reserved.
Documents / Resources
|
CHUANGO DWC-102 Wireless Door Window
Contact
[pdf] User Manual
DWC-102, Wireless Door Window Contact, Door Window Contact, Window Contact,
DWC-102, Contact
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>