CHUANGO WI-210 Water Flood Detector User Manual
- June 5, 2024
- CHUANGO
Table of Contents
WI-210 Water Flood Detector
User Manual
Introduction
This is a contact wireless water detector, which works based on the theory of liquid conductivity. The performance is reliable and the installation is easy. When the liquid reaches the two probes of the detector, it will send a wireless signal to the control panel. It can be widely used in computer rooms, warehouses, and any places that need to be protected from water. Two pieces of AAA 1.5V LR03 0batteries are included in the detector, which enables 12 months of standby.
Product Overview
LED Indication
Flash once:
The liquid is detected, sending a wireless signal to the control panel.
Flash once every two seconds:
Low battery, please replace the battery immediately.
Connect to the Control Panel
Make sure the control panel is under learning status, press the tamper switch, or simulate an alarming case. When the signal is received and one beep is heard, they are connected successfully.
Installation
- Remove the insulated strip, the detector will enter working mode.
- Use a screw to fix the probe horizontally on the detection site.
- Use double-sided adhesive tape to fix the transmitter in the place where the liquid is unable to reach, and keep the antenna upward.
Change Batteries
Take off the back case with the screwdriver, and replace the batteries with new ones according to the positive and negative marks.
Specifications
Power supply: DC 3V (AAA 1.5V LR03 x 2 PCS)
Static current: <29 uA
Alarm current: <22.2 mA
Transmitting distance: <80m (in open area)
Radio frequency: 315 MHz/433.92MHz (±75KHz)
Europe/Australia: 433MHz
Housing material: ABS plastic
ERP(dBm) Max.: -16.5
Operation condition:
Temperature: -20°C-+50C
Relative humidity: <95% (non-condensing)
Detector dimensions (L x W x H): 54X14.5X107mm
Probe dimensions (L x W x H): 35X30X15mm
CE Declaration of Conformity
Hereby, Chuango AloT GmbH declares that the radio equipment type WI-210 is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
https://www.chuango.com/english/compliance_WI-210
INFORMATION FOR THE USERS
At the end of its life, the device has to be separated from the other
waste. Consign the device and all its components together to a center of
electronical and electrotechnical waste recycling center, designated by your
local authorities.
2006/66/EC and its amendment 2013/56/EU (battery directive): This product
contains a battery that cannot be disposed of as unsorted municipal waste in
the European Union. See the product documentation for specific battery
information.
The battery is marked with this symbol, which may include lettering to
indicate cadmium (Cd), lead (Pb), or mercury (Hg). For proper recycling,
return the battery to your supplier or to a designated collection point. For
more information see: www.recyclethis.info.
Ver WI-210-UM-EN-VI 1
© 2021 Chuango. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>