INBAY 241050-01 Wireless Charging Application User Manual
- June 3, 2024
- INBAY
Table of Contents
INBAY 241050-01 Wireless Charging Application
Wireless Charging Application
dimensions
INTEGRATED FOREIGN OBJECT DETECTION (FOD)
IMPORTANT INFORMATION:
Please don‘t place any other objects such as coins, credit cards etc. onto the
INBAY surface. Especially smartphones with attached ring stand holder must not
be used! – otherwise the integrated Foreign Object Detection (FOD) will
interrupt wireless charging for safety reasons.
ATTENTION! After installation, devices/consumers with more than 5A / 60W shall not be operated on the +12V socket. Otherwise a risk of overvoltage can occur!
IMPORTANT! AFTER INSTALLATION THE MANUAL HAS TO BE PLACED INTO THE DASH BOARD OF THE CUSTOMER‘S CAR
FCC
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this
device could void the user’s authority to operate the equipment. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that
may cause undesired operation.
RF Exposure warning
This equipment must be installed and operated in accordance with provided
instructions and the antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or
transmitter. End-users and installers must be provide with antenna
installation instructions and transmitter operating conditions for satisfying
RF exposure compliance.
ISED
Industry Canada Equipment Standard for Digital Equipment (ICES) –Canada Compliance Statement This Class B digital apparatus complies with Canadian ICES-003. CAN ICES-3 (B)/NMB-3(B) Cet appareil numérique de la classe B est conforme à la norme ICES-003. CAN ICES-3 (B)/NMB-3(B) du Canada. Innovation, Science and Economic Development Canada (ISED) Compliance Statement This device complies with ISED’s licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Innovation,
Science and Economic Development Canada (ISED) radio frequency exposure
limits. The Wireless Device should be used in such a manner such that the
potential for human contact during normal operation is minimized. This device
has also been evaluated and shown compliant with the ISED RF Exposure limits
under mobile exposure conditions. (antennas are greater than 20 cm from a
person’s body).