ancona AN-5309 Comfort 6 Dual Towel Warmer User Manual

AN-5309 Comfort 6 Dual Towel Warmer
User Manual

Comfort 6 Dual Towel Warmer
User Manual & Installation Instructions

****IMPORTANT SAFETY INSTRUCTIONS

Carefully read the important information regarding installation, safety, and maintenance. Keep these instructions for future reference.
MAAN5309-02 2020-07-02

Required Tools

Electrical requirements: 120V, 80W, 60Hz, 0.67A. MUST HAVE A GROUND CONNECTION. Should be protected by a 15 amp GFI circuit breaker or equal. READ ALL INSTRUCTIONS IN THE MANUAL BEFORE INSTALLING THIS TOWEL WARMER.

Before You Begin

Unpack the towel warmer carefully to avoid any damage or loss of any part. When opening the box, care should be taken to not discard packets of mounting screws. It is your responsibility to immediately inspect for any damage. Shipping damage should be reported immediately to your place of purchase.
Follow instructions to make sure your towel warmer is properly installed. FAILURE TO FOLLOW THESE STEPS COULD RESULT IN HAZARDOUS CONDITIONS.
To avoid possible fire hazards, the Towel Warmer must be mounted as intended. MOUNT THIS UNIT AS SHOWN IN THESE INSTRUCTIONS.
The towel warmer must be used in accordance with any prevailing code and relevant electrical wiring rules and regulations, in particular regulations that cover the use of products and accessories in damp situations such as showers, laundries, and other areas with fixed water containers.

• Towel Warmer must be mounted vertically with cord in position as shown. No other position is safe or recommended.
• To provide continued protection against the risk of electrical shock, connect to a properly grounded outlet only.
• Towel Warmer must be securely mounted to the wall. When possible, the Towel Warmer should be attached to adequate blocking or framing. Installations, where blocking or framing is not available, must use appropriate wall anchors for mounting directly to sheetrock.

CAUTION:

1. Approved for domestic use only. Do not use outdoors.
2. Install in accordance with national and local codes.
3. Do not install in the shower, sauna, or any wet locations.
4. Make sure the towel warmer is properly secured to the wall before use.

Do not locate the towel warmer within the shower/tub zone
For illustrative purposes only

• Failure to follow the installation instructions may lead to overheating and malfunction.
• Any repairs that involve opening the Towel Warmer must be carried out by the manufacturer or their representative.
• Please contact your supplier in the event of any problem or if repair is needed.

Product Dimensions

Parts for Plug-In Wall Mount Installation Plug-In Installation

•  Insert screw (b) to the connecting tube (a).

• Use a screwdriver to attach screw (b) and tube (a) to the nut on the back of the frame.

• Please check provided mounting screws and wall anchors are suitable for your home’s construction.

• Drill the holes and insert the plastic screws (f) into the wall, then insert (c) and screw (g) to fix the support.

• Mount the unit on support and tighten all the set screws (e) to the mounting tube (a) with the Allen key.

Parts for Hardwire Wall Mount Installation

Hardwire Installation

• Insert screw (b) to the connecting tube (a).

• Use a screwdriver to attach screw (b) and tube (a) to the nut on the back of the frame.

• Please check provided mounting screws and wall anchors are suitable for your home’s construction.

• Drill the holes and insert the plastic screws (f) into the wall, then insert (c) and screw (g) to fix the support.

• Cut cable and leave its length at 25 cm (9.8 in.).

• Insert cable through tube (d) and plate (h).

• Insert screws (i) to plate (h).

• Connect unit.
  All electrical connections in the junction box must be performed by a fully qualified electrician.
  

• Mount the unit on support and tighten all the set screws (e) to the mounting tube (a) with Allen key.

• Fasten screws (i) to plate (h).

Operation and Maintenance Instructions

• After installation, connect the electric power and turn on the switch. The indicator light will show red and the towel warmer will start to work.
• Turn off the switch when the towel warmer is not in use. The indicator light will turn dark and the towel warmer will stop working.
• When cold, clean the towel warmer with a soft dry towel. Do not clean with abrasive cleaning powder. r Unplug the unit if not in use for a long period of time.

CAUTION – Overlapping towels may increase towel warmer temperatures.

• PROPERLY HANG TOWELS.
• DO NOT OVERLAP TOWELS.

NOTE: There is no limit to how long a towel warmer can stay on. However, in order to conserve the life expectancy of our Ancona towel warmer, we recommend that the unit is on consecutively for no more than two to three hours at a time.

• **** According to the National Electrical Code, all electrical work must be carried out by authorized licensed professionals. For your safety, please ensure you adhere to these regulations.
• Please ensure the power cord does not come in contact with the rail during operation.
• The power code is the means of disconnecting the unit from the main power outlet.
• The Towel Warmer will be hot. Please exercise caution if the Towel Warmer is accessible to children or the elderly. Please ensure that children are supervised at all times in the vicinity of the Towel Warmer and warn them that it is a hot surface that can cause burns.

HIGH OPERATING TEMPERATURE!

• Towel warmers are designed for heating towels and bathrobes and should not be used for other purposes. The manufacturer or reseller assumes no liability if the device is used in combination with equipment or accessories not sold by the manufacturer.

• This towel warmer is to be only used with fabrics that are water washable. Towels that contain soap or detergent residue may appear to have scorch marks; however, this is simply discoloration of the residue in the towels themselves. The unit does not reach a temperature sufficient to scorch towels.

• Never stand, sit or climb on the unit.

• This towel warmer operates at high temperatures that can cause burns. Do not touch the surfaces of the towel warmer while the warmer is in operation. The unit is designed to warm up towels and may become very hot.

• Do not allow unsupervised children in the vicinity of the towel warmer and warn children of hot surfaces.
  An adult must supervise when the device is used by or near children.

• Unplug the unit with a dry hand and ensure that the electrical circuit breaker is of the main panel before wiring, carrying out a repair, or servicing your heated towel warmer.

• Do not place your towel warmer inside a shower, sauna, or plunge into the water.

• To ensure continued protection against the risk of electric shock, plug the unit into a properly grounded outlet

• Approved for domestic use only. Do not use outdoors. Information: service@anconahome.com or 1-800-350-4562

Installation

Stretch out both ends by hand.
Place the hook on the bar.
Stretch out the hook to avoid scratching the bar.
Finished.

Please register your product warranty by visiting the Ancona Home website.
Canada & USA
Phone: 1-800-350-4562
Fax: 800-350-8563
Email: service@anconahome.com
Website: www.anconahome.com
© 2020 Copyright of Ancona Home. All rights reserved.
This material may not be reproduced, displayed, modified, or distributed.
MAAN5309-02

References

• Ancona Home | High Quality Kitchen & Bathroom Products

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>