i Safe MOBILE M120A01 IS120.2 Mobile Phone User Manual

: June 5, 2024
: i safe MOBILE

Table of Contents

i Safe MOBILE M120A01 IS120.2 Mobile Phone
SAFETY
DEVICE OVERVIEW/FUNCTIONS
PREPARATION
SWITCHING ON
CHARGING
CONNECTING APPROVED ACCESSORIES
MAINTENANCE/REPAIR
CLEANING
STORAGE
RECYCLING
TRADEMARKS
CONTACT/SERVICE CENTRE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

i Safe MOBILE M120A01 IS120.2 Mobile Phone

i-Safe-MOBILE-M120A01-IS120.2-Mobile-Phone-image

FIRST

This Quick Start Manual contains all the important health and safety instructions for using the device IS120.2 (model M120A01) safely.

Read the “Safety” section of this Quick Start Manual carefully before using the device. If you do not follow these instructions or do not understand them, this could lead to death, severe injuries and damage to the device.
Read the Operating Manual before using the device.
The Operating Manual with detailed information and instructions concerning the device can be found at www.isafe-mobile.com/en/support/downloads.
Also read the Safety Instructions before using the device. These can be found in the device packaging and at www.isafe-mobile.com/en/support/downloads.
Follow all instructions given on the device and on the packaging.
Follow local safety regulations.

SAFETY

USE IN EXPLOSION HAZARDOUS AREAS

Only use the device in explosion hazardous areas of zones 2/22 or outside of explosion hazardous areas.
Before entering a explosion hazardous area with the device,
- make sure that only approved accessories are connected to the device, see section “Connecting approved accessories”,
- make sure that no gap can be seen between the two halves of the device,
- make sure the device is not damaged,
- make sure that all the labels on the device are readable,
- make sure the battery compartment is screwed tight.
If you use the device in a explosion hazardous area,
- do not loosen the screws on the device,
- do not connect any accessories to the device,
- do not open any interface cover,
- do not charge the device,
- do not open the device,
- do not damage the device.
Switch off the device immediately and leave the explosion hazardous area without delay if
- malfunctions occur on the device,
- you have damaged the housing of the device,
- you have exposed the device to excessive loads,
- the labels on the device are no longer readable.

USE OUTSIDE OF EXPLOSION HAZARDOUS AREAS

Do not modify the device structurally.
Do not expose the device to high temperatures.
Do not expose the device to strong UV radiation.
Do not expose the device to processes with high electrical charges.
Do not expose the device to aggressive acids or bases.
Do not use the device in places where its use is prohibited.
Turn off the device in clinics or other medical facilities.
Always keep a safety distance of at least 15 cm between the device and a pacemaker or hearing aid.
The device can affect the functioning of medical devices such as pacemakers and hearing aids.
When using the device while driving a motor vehicle, be sure to comply with applicable national laws.

DEVICE OVERVIEW/FUNCTIONS

i-Safe-MOBILE-M120A01-IS120.2-Mobile-Phone-fig1

SENSORS: Proximity sensor, light sensor.
LOUDSPEAKER
LOUDNESS CONTROL: Volume up/Volume down.
FUNCTION KEY (RED FUNCTION KEY): Optional key used by different apps.
BACK KEY: Go to the previous screen.
DELETE KEY: To delete characters entered incorrectly.
POWER KEY: A long press switches the device on/off. A short press ends a call.
CHARGING CONTACTS
NAVIGATION RING AND CONFIRMATION KEY
KEYPAD
ANSWER KEY
FUNCTION KEY (M1): Optional key used by different apps.
HOME KEY: Switch to the main screen.
FUNCTION KEY (SIDE KEY): Optional key used by different apps.
NOISE CANCELLING: Noice cancelling microphone.
EYELET: Eyelet for hand strap.
LOUDSPEAKER: Speaker for hands-free function.
BATTERY COMPARTMENT
USB INTERFACE: Connection for the Micro USB Cable. Also see sections “Charging” and “Connecting approved accessories”.

PREPARATION

Loosen the screws on the battery compartment using the Screwdriver provided.
Remove the battery compartment cover.
Insert the SIM card into the slot. The slot is marked „SIM“.
Place the battery in the battery compartment.
Check that the battery is seated correctly and securely.
Reinstall the battery compartment cover and hand-tighten the screws using the Screwdriver provided.

SWITCHING ON

Press and hold the on/off key for about 3 seconds.
When turning on the device for the first time, follow the instructions on the screen.
Enter the device or SIM PIN when the input dialog for the device or SIM PIN appears after switching on.

CHARGING

Only charge the device outside of explosion hazardous areas.
Do not charge the device in the vicinity of flammable substances.
Only charge the device using the Micro USB Cable supplied.
Only charge the device at ambient temperatures between +5 °C to +35 °C (+41 °F to +95 °F). Charge the device under dry indoor conditions only.
Do not charge the device in environments dusty or humid.
Connect the adapter suitable for your country to the power supply unit.
Connect the Micro USB Cable to the power supply unit.
Connect the Micro USB Cable to the USB interface of the device.

CONNECTING APPROVED ACCESSORIES

Only connect accessories approved by i.safe MOBILE to the device. Accessories approved by i.safe MOBILE can be found at www.isafe-mobile.com/en/products.
Only use USB interface outside of explosion hazardous areas.
Under no circumstances should you open the cover of the USB interface in explosion hazar-dous areas.
Approved accessories can be connected to the USB interface. The USB interface is used for charging and data transfer.
Connect approved accessories or other devices to the USB interface only by using the Micro USB Cable.

MAINTENANCE/REPAIR

Contact the i.safe MOBILE repair service at www.isafe-mobile.com/en/support/service if the device is not working normally, if the device needs to be repaired or if a replacement part is required.

RETURN SHIPMENT
Contact the i.safe MOBILE repair service at www.isafe- mobile.com/en/support/service.

CLEANING

Turn off the device before cleaning.
Do not charge the device while cleaning.
Do not use chemical agents for cleaning.
Clean the device and the Power Adapter with a soft, moistened antistatic cloth.
Clean the display screen regularly with a soft, antistatic cloth.

STORAGE

Store the device at ambient temperatures between +5 °C to +35 °C (41 °F to +95 °F) and a humidity between 10 % to 60 %.

RECYCLING

DO NOT throw away batteries with household waste.
Always dispose electronic products, batteries and packaging material at the appropri-ate collection points. This way, you prevent uncontrolled waste disposal and promote the recycling of material resources.
You can obtain further information from regional waste disposal companies, state authorities or the i.safe MOBILE service centre responsible for your country or region at
www.isafe-mobile.com/en/support/service.

TRADEMARKS

i.safe MOBILE and the i.safe MOBILE logo are registered trademarks of the i.safe MOBILE GmbH.
All other trademarks and copyrights are the properties of their respective owners.