BAKKER ELKHUIZEN DXT 0156 Precision Mouse User Guide
- June 5, 2024
- BAKKER ELKHUIZEN
Table of Contents
User Guide
Congratulations
Congratulations on your purchase of the DXT Mouse. You have just taken your first step towards comfortable and productive computing.
Getting Started
Wired version
The DXT Mouse Wired is Plug and Play. No additional software is required.
Plug the USB cable into an empty USB computer port. For more features please
go to the “Using the DXT Mouse” section on page 4.
Wireless version
The DXT Mouse Wireless is Plug and Play. No additional software is required.
Step 1 – Plug your dongle in
Insert DXT USB dongle (E) into the empty computer USB port.
Step 2 – Charge your DXT Mouse.
Plug the USB cable (A) into an empty computer USB port and DXT Mouse mini USB
port and charge fully for a full charge of 90 minutes. To indicate charging
the two red L/R LEDs (D) will light up when the battery is being charged and
go off when the mouse is fully charged.
Note the DPI button (B) and R/L button (C) will not work while charging but
all other features can still be used.
Quick Charge System
Charging the mouse for 30 seconds allows up to two hours normal of use.
Long Battery Life
A full charge (90 minutes) allows up to two weeks of normal use.
Auto Power Off
DXT Mouse will auto power off when not being used.
Holding the DXT Mouse
How to hold the DXT Mouse
When holding the mouse, place your thumb in the center of the curved ridge on
the back of it (figures 3 and 4).
Allow your fingers to curl naturally around the front of the mouse to take up
one of the positions shown in Figures 5 and 6.
Press the button (C) beneath the thumb surface to select either left or right-
hand use – the blue light will illuminate under L (Figure 1) for left-hand use
or R for right-hand use (Figure 2).
|
---|---
1. Mouse set for left-hand use| 2. Mouse set for right-hand use
|
3. Mouse set for right-hand use| 4. Mouse set for left-hand use
|
5. Left-hand front view| 6. Right-hand front view
Using the DXT Mouse
How to change from right to left-hand use
The DXT Mouse is set to right-handed by default.
You can switch hands by simply pressing the R/L button (C). Press this button
once. The LEDs (D) will flash once to indicate which setting you have
selected.
How to change the speed of the DXT Mouse Cursor (DPI)
The default setting is 1000 DPI. To adjust your DPI press button (B). 1 flash
= 500 DPI, 2 flash =1000 DPI, 3 flash =1500 DPI, 4 flash = 2000 DPI.
You can adjust the DXT Mouse buttons, cursor speed, and design in the control
panel within your computer.
http://windows.microsoft.com/en-GB/windowsvista/Change-mouse-settings
|
---|---
1. Mouse set for left-hand use| 2. Mouse set for right-hand use
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>