PROFECO 77419 Snel lader 20V 2.0Ah Instruction Manual

: June 5, 2024
: Profeco

Table of Contents

PROFECO 77419 Snel lader 20V 2.0Ah
Description of symbols
Additional safety requirements for the battery charger
List of main parts
Technical specifications
Battery charger
Storage
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PROFECO 77419 Snel lader 20V 2.0Ah

Description of symbols

The use of symbols in this manual is intended to draw your attention to possible risks. The safety symbols and their explanations must be perfectly understood. The warnings in themselves do not eliminate the risks and cannot replace the correct actions to prevent accidents.

WARNING – To reduce the risk of injury, the user must read the operating instructions.
Before each use, refer to the appropriate section in these operating instructions.
Complies with the relevant European regulations.
Class II transformer.
For indoor use only.
The symbol of the crossed-out wheeled bin indicates that the item must be disposed of separately from household waste. The item should be returned for recycling in accordance with the local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the amount of waste sent to incinerators or landfills and minimize any negative impact on human health and the environment.

Additional safety requirements for the battery charger

This device may be used by children aged 8 and above and by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge if they are supervised or instructed in the safe use of the device and understand the hazards involved.
Children should not play with the device.
Cleaning and user maintenance must not be carried out by children without supervision.
For indoor use only.
Warning do not charge non-rechargeable batteries.
This charger may only be used for charging PROFECO batteries.
The external flexible cable of this transformer cannot be replaced; if the cable is damaged, the transformer must be disposed of.
Before using the charger, read all instructions and warning marks on the charger and the battery pack.
Charge your battery pack only indoors, as the charger is designed for indoor use only.
DANGER: If the battery pack is ruptured or damaged in any other way, do not insert it into the charging base. There is a danger of electric shock or electrocution.
WARNING: Do not allow any liquid to come into contact with the charger. There is a danger of electric shock.
The charger is not intended for use other than charging the exact type of rechargeable battery supplied with the charger. Any other use may pose a risk of fire, electric shock or electrocution.
The supplied charger and battery pack are designed to work together. Do not attempt to charge the battery pack with a charger other than the one supplied.
Do not place any objects on top of the charger as this may cause overheating. Do not place the charger near a heat source.
Pull-on the charger to disconnect it from the power source. Do not pull on the cord.
Make sure that the charger cord is not stepped on, tripped over, damaged or pressurized.
Do not use an extension cord unless it is absolutely necessary. Using an incorrect extension cord may result in fire, electric shock or electrocution.
Do not use the charger if it has been subjected to a severe impact, dropped or otherwise damaged. Take the charger to an authorized service center for inspection or repair.
Do not disassemble the charger. Take it to an authorized service centre when service or repair is required. Improper reassembly may result in fire, electric shock or electrocution.
To reduce the risk of electric shock, unplug the charger before cleaning it. Simply removing the battery will not reduce the risk.
The charger is designed for use with a standard domestic power supply. Do not attempt to connect the charger to a power supply with a different voltage.
Do not expose the charger to water, rain or snow.
Never try to connect two chargers to each other.
Never insert objects into the ventilation holes of the charger. This can cause an electric shock or damage the charger.
Unplug the charger before cleaning it. This reduces the risk of electric shock. Removing the battery does not reduce this risk.
Never charge a battery that is already fully charged.

List of main parts

Charging indicator
Charging insert

Technical specifications

Battery charger

Battery charger

The supply voltage must correspond to the voltage indicated on the type plate of the rapid charger. Always inspect the battery charger, cord and plug before use. Always have the damage repaired by a qualified professional. Protect the battery charger from moisture and only use it in dry areas. The battery charger supplied is only suitable for charging batteries.

Plug the battery charger into the mains.
The green light is on to indicate that power is connected.
Slide the battery into the charger as shown in Fig.1.
When the battery is being charged, the green light will remain lit and the red light will continue to flash.
Both the green and red lights will remain on when the battery is fully charged.

Storage

Keep the machine, operating instructions and any accessories in the original packaging. In this way, you will always have all the information and spare parts to hand.
Pack the unit securely or use the original packaging to prevent damage during transport.
Always store the unit and accessories in a dry place.