strex SP18 Car Stereo Single DIN Radio Instruction Manual
- June 5, 2024
- STREX
Table of Contents
strex SP18 Car Stereo Single DIN Radio
INTRODUCTION
Thanks for choosing Strex! Read the manual carefully, for correct and safe operation of the product. Always follow these instructions for safe usage. If you have any questions about the product or encounter problems, you can contact us by email: info@strex.nl
Strex Car Stereo 1-DIN
You get the most out of your car ride with a good radio. Tune in to your favorite radio station or immediately switch to AUX or Bluetooth. Fines for not calling hands-free are a thing of the past thanks to the built-in microphone in the Strex car radio. Phone almost empty? No problem. You can always charge the phone thanks to the USB port.
Getting started
The illustrations in this manual have been created with care. However, some parts of the product may differ from the illustration shown in this manual. In that case, Strex is not obliged to adjust the part or the manual. This manual is intended for the end user of the product. Using the table of contents on the next page you can find the necessary information in the manual.
WARNING
Improper use of this product and accessories are dangerous to you and others
and can damage, destroy or cause a serious accident. We therefore ask you to
read the manual carefully and to read and strictly observe the danger, safety
and warning messages.
INSTALLATION/CONNECTIONS
Note : specifications and the design are subject to possible modification without notice due to improvement.
SPECIFICATIONS
FM TUNER
-
Frequency Range
87.5~108.0 -
Sensitivity
12dB μV -
I.F. Frequency
10.7MHz -
Frequency Response
40Hz~15KHz(±3dB -
Stereo Separation
28dB -
S/N Ratio
50dB
GENERAL
-
Power Supply Voltage
12V DaC, Negative Ground -
Max Current Consumption
15A -
Max Output Power
4x60W
OPERATION MANUAL
[
](https://manuals.plus/wp-content/uploads/2022/05/strex-SP18-Car-
Stereo-Single-DIN-Radio-fig-2.png)
LOCATION OF CONTROL
- Power ON/OFF
- Function Selector (radio/usb/sd/aux-in/bt) & End call
- Auto Seek Search Tuning (AMS)
- Band Button (FM1-FM2-FM3) & Answer call
- Track Skip/ Search Forward/ Backward ,
- Manual Auto Search Radio
- Memory Station 1-6 for Radio and Play/pause Function for MP3/WMA
- Intro Function for MP3/WMA
- Repeat Function for MP3/WMA
- Random Function for MP3/WMA
- 10 Function for MP3/WMA
- +10 Function for MP3/WMA
- SD Card Slot
- Aux In Jack
- USB Port
- LCD Display
- Volume / Select Control
- Reset Button
- EQ Button
- CLK Button
Bluetooth: Search for Bluetooth devices on your phone. Pair to device using the password “0000”. Some phones automatically connect to the radio after searching.
OPERATING INSTRUCTIONS
-
POWER ON/OFF
Short press turn on, long press three seconds turn off. -
MODE–FUNCTION SELECTOR
Push this button repeatedly and the lcd will display the following sequence: RADIO —> USB —> SD —>AUX -IN —>BT. In bluetooth mode, short press to end call. -
AUTO SEEK SEARCH TUNING (AMS)
In Radio Mode, short press for the browser, and long press to automatically save the station.
In playback, the function is to choose the song. -
BAND BUTTON
In radio mode, each band is toggled cyclically by pressing the key FM1-FM2-FM3. -
/6. BUTTON
Track skip in MP3 player mode (USB/sd/MMC) / radio search; Press the button during playback to go to the desired track; Press to search to the desired radio station. -
1/ BUTTON
Memory stations 1-6 for radio control the playback of your music coming through the usb or sd/ mmc external device by pressing once to start playback. During “play” repress the button to pause playback. Press the button once more to resume play. -
2/INT BUTTON
When this button is pressed, the ‘INT’ indication is displayed and the first several seconds of each track is played. Press again to stop intro and listen to track. -
3/RPT BUTTON
When this button is pressed, the ‘RPT’ indication is displayed and the selected track will be continually repeated until the track repeat mode is cancelled by pressing the ‘RPT’ button again. -
4/RDM BUTTON
When this button is pressed, the ‘RDM’ indication is displayed and the tracks are played in random instead of normal progression. To cancel random mode, press the ‘RDM’ button again. -
5/-10 BUTTON
In playback mode, short press to -10, and long press to choose a folder. -
6/+10 button
In playback mode, short press to +10, long press to choose a folder. -
SD CARD SLOT
Insert the SD/MMC card in the slot by pushing it gently inward. Select SD with the mode selector. The music starts to play automatically. * Supports music file format: MP3,WMA. -
AUX IN JACK
Insert your portable player into the jack, in any playing mode, audio will come through the car speaker. -
USB PORT
Use a usb cable (not included) if necessary, to connect your portable mp3 player. -
LCD DISPLAY
The LCD display show the actual reception and function. -
VOLUME / SELECT CONTROL
Rotate the volume knob to control the volume. To select other function, Press the select button shortly until the desired function is shown on the display.
-
volume (rotate knob) —> select (push down) —>bass—>treble balance—>fader—>loud—> EQ (flat-pop-classic-rock)
-
RESET BUTTON Restore factory defaults.
-
EQ & LOUD BUTTON
EQ (flat-pop-classic-rock); Loudness ON/OFF -
.CLK BUTTON
Electronic clock button.
-
FCC WARNING:
FCC ID: 2ABQZ-JSD
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>