infobit iMeeting-PT21 smart wireless presenter User Manual
- June 5, 2024
- infobit
Table of Contents
User Manual
iMeeting PT21 Smart Wireless Presenter 
www.infobitay.com
info@infobitay.com
Safety Notice
Please read this notice before you use the dicker.
USE
- Check battery state on software.
- Plug USB receiver back to clicker after use in case of loss.
- Recharge if there is a flashing red light.
ENVIRONMENT
- A strong Electromagnetic wave environment will interrupt use.
- Do not put the remote on the fire.
- Operating temperature 0-40 Fahrenheit Degrees.
- The remote is not able to use while charging.
EQUIPMENT
- Do not disassemble the clicker.
- Any sharp object that would damage the clicker is not allowed.
- Avoid extrusion, collision, and dropping.
- Keep the clicker in a dry environment, it is not waterproof.
Copyright
Both hardware and software design are protected. All rights reserved.
Button Introduction
- Previous/Up: Click the button to go to the previous page or rewind your video.
- Next /Down: Click the button to go to the next page or fast forward your video.
- Do/Execute Function: Long press the button to perform different functions.
- Select Function: Click to shift to different functions, such as Mouse, Spotlight, Digital laser, Zoom, and Mark.
How to start
As shown in the following pictures, first, connect a USB cable to your
computer and install the software of the presenter which is ready in built-in
USB RAM.
Second, unplug the USB receiver and connect it to your personal computer and
activate the drive.
Third, long-press the NEXT button and
the SELECT FUNTION button together, and you will see the flash green light on
the top side, and the device will vibrate about ls, which means the receiver
and the clicker match successfully. If the green light is off in the 20s and
there is no vibration, means the match fails, please unplug the USB receiver
and start the procedure over again. For the first time you plug the USB
receiver into your personal computer after you Unpack the remote, the system
will install software of the remote automatically and successfully in 30
second, restart or try another USB port of the computer if the Installation
process goes too slow or failed. When the software is installed successfully,
click any button on the remote, if you feel the vibration of the remote, start
to use it and enjoy your presentation. 
Combined-buttons Function
- Long press the DO and press the PREVIOUS button at the same time, it allows you to enlarge the Spotlight or Laser Spot, and narrow them with press the DO and NEXT buttons together.
- Exit any function mode by clicking UP/DOWN and enter again by long-press DO.
- PPT full-screen mode: Long press the page up button for 2 seconds to enter the PPT full-screen state, and long press again to exit the full-screen state.
Notice: The presenter software works with Windows 7 or above, Mac OS x 10.9 or above.
Packing List
- Presentation Clicker x 1
- USB cable with 8GB ram x 1
- User Manual x 1
- Leather Case x 1
Warranty
- For the remote, 1-year free maintenance and free replacement if it cannot be repaired due to quality problems. For accessories, free replacement in 3 months.
- Warranty is valid on the basis of quality problems, any physical damage or burn is not applicable.
- Normally your remote will be ready in 10 days if reparable, otherwise, we will replace you with a new one.
- The customer will be responsible for the express charges for sending the remote to the repair location, we will be responsible for express charges for sending the remote back.
| Name | Contact |
|---|---|
| Date | Problem |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>