infobit iWall 409R Windows Software User Manual

June 5, 2024
infobit

infobit iWall 409R Windows Software User Manual
infobit iWall 409R Windows Software

Choose Connect Mode

Internet mode:

Plugging RJ45 cable into the host computer and controller. (specific operation refer to the picture )

Choose Connect Mode

Choose Connect Mode

  1. Open control program, enter IP address and Port num.
  2. Click “connect

Internet mode Computer IP address setting:
Choose Connect Mode

  1. Right-click the “Network”, click the Open Network&Internet settings
    Choose Connect Mode

  2. Click change network settings
    Choose Connect Mode

  3. Right-click the internet been connect.

  4. Select properties

  5. Select (TCP/IPV4)

  6. Click properties
    Choose Connect Mode

  7. Select Use the folloing IP address

  8. Change the IP address to 192.168.1.(from2-254)

RS232 mode:

Two sides of connecting cable (Serial mode)

  1. Find the corresponding port
  2. Right-click “This PC” .
  3. Select “Properties”
  4. “Device Manager”
  5. figure out which USB interface be plugged

Find the corresponding port

  1. Set connection mode
    Set connection mode

  2. Click “Clear Serial”.

  3. select the plugged COM interface.

  4. Click “Confirm Mode”(don’t need to choose “Baud Rate”)

  5. Click “Connect”

Select screen splicing mode

  1. Typing or click the button to select screen joint mode.
  2. Click ok.
    Select screen splicing mode

Select display mode

Display mode introduction

Display mode introduction
Single Mode

Display mode introduction
Left-Right Mode

Display mode introduction
Up-down mode

Display mode introduction
PIP mode

Display mode introduction
Four window mode

Select “Input window mode” &“Input sources”

A. Left&right mode

  1. Select “Input window mode”
  2. Drag “input source” and drop into the “Left Screen”
  3. Drag “input source”and drop into the “Right Screen”
    Left&right mode

B. PIP mode (Only could be used in Signal mode)

  1. Click PIP mode
  2. Drag “input source” and drop into the “Little Screen”
  3. Drag “input source” and drop into the “Large Screen”
    PIP mode

Tips:
The location & size of “sub picture” could be controlled by the marked controller.

http://www.bitvisus.com/

info@infobitav.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals