KLARSTEIN 10034462 Ice Cube Maker Instruction Manual

COOLIO
Ice Cube Maker
****10034462
www.klarstein.com

Dear Customer,
Congratulations on purchasing this device. Please read the following instructions carefully and follow them to prevent possible damage. We assume no liability for damage caused by disregard of the instructions and improper use. Scan the QR code to get access to the latest user manual and more product information.

https://use.berlin/10034462

TECHNICAL DATA

SAFETY INSTRUCTIONS

• Check that the mains voltage corresponds to the rating of the appliance before operating.
• Use handles or knobs when moving. Place on a flat stable surface for use. Do not use outdoors.
• Do not use near or in the immediate vicinity of a bath or swimming pool or any source of liquid.
• Unplug from socket outlet when not in use.
• To protect against electric shock, do not immerse the cord or plug in water or any other liquid.
• The use of accessory attachments not recommended by the appliance manufacturer may cause injury.
• Do not locate this appliance immediately below a socket outlet.
• Do not allow the cord to overhang the countertop where it can be easily pulled by children.
• Do not overfill as this may cause a hazard. Ensure lid is closed when in operation.
• To remove plug from the outlet, do not pull on supply cord. Grasp the plug firmly and pull to remove it.
• Do not use this appliance for anything else other than its intended use. No liability can be accepted for any damage caused by non-compliance with these instructions or any other improper use or mishandling.
• This appliance is for household use only.
• This appliance is not intended to be operated by means of an external timer or separate remote control system.
• This appliance is not intended to be immersed in water.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
• Please according to local regulations regarding disposal of the appliance for its flammable blowing gas.
• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• Fill with potable water only.
• This device may be only used by children 8 years old or older and persons with limited physical, sensory and mental capabilities and/or lack of experience and knowledge, provided that they have been instructed in the use of the device by a responsible person who understands the associated risks.

This appliance contains the coolant isobutane (R600a), a natural gas that is environmentally friendly. Although it is flammable, it does not damage the ozone layer and does not increase the greenhouse effect. The use of this coolant has, however, led to a slight increase in the noise level of the appliance. In addition to the noise of the compressor,you might be able to hear the coolant flowing around the system. This is unavoidable and does not have any adverse effect on the performance of the appliance. Care must be taken during the transportation and setting up of the appliance so that no parts of the cooling system are damaged. Leaking coolant can damage the eyes.

WARNING
Danger from fire/flammable materials. Please observe the local regulations for the disposal of units with flammable refrigerants and gases.

• Keep ventilation openings in the unit housing free of obstacles.
• Do not damage the refrigerant circuit.
• Do not use any mechanical devices or other means to accelerate the defrosting process or the ice recovery process.
• Do not use other types of electrical appliances inside the ice cube machine.

Special Notes

• When positioning the unit, make sure that the power cord is not pinched or damaged.
• Make sure that there are no multiple sockets or power supplies on the back of the unit. To avoid contamination of food, please follow the instructions below:
• Regularly clean surfaces that may come into contact with food. Clean the water drain regularly.

WARNING
When using, servicing, and disposing of the unit, pay attention to the left symbol on the rear of the unit or on the compressor. This symbol warns of possible fi res. There are flammable substances in the refrigerant lines and in the compressor. Keep the appliance away from sources of fire during use, maintenance, and disposal.

PRODUCT OVERVIEW

1. Buttons
2. Control panel
3. Top Cover
4. Transparent lid
5. Microswitch bracket
6. Evaporator
7. Water box
8. Ice shovel board
9. Ice Basket
10. Water Reservoir
11. Front big body
12. Motor bracket
13. Rear big body
14.  Cooling power

CONTROL PANEL OPERATION

1. POWER: Plug in the power and the source indicator flashes. Press the POWER button, the power indicator light is always on, the machine will start the de-icing function first, then the ice block will be automatically produced according to the selected mode. After the ice-making is completed, the ice will be removed, and then the ice-scraping function will be entered.
2. SELECT: Select the ice size mode. The default is the big ice production mode. The selected mode: SMALL: small ice selection. LARGE: big ice selection, the corresponding indicator light is on. The production time of small ice is 8 minutes and 30 seconds, and the production time of big ice is 9 minutes and 30 seconds.
3. CLEAN: After cleaning the button, press the cleaning button, start the motor, then start the pump to pump water, so cycle, stop for 4 minutes.
4. ADD WATER: Water shortage alarm: When this red is on, it means there is a water shortage in the water tank. You need to add water and press the POWER button to restart the machine.
5. ICE FULL ice alarm: When the ice reaches the maximum amount of ice storage container, the “ICE FULL” light flashes and the machine stops. At this time, the ice
   needs to be poured out. When the ice position is lower than the full sensor position, the machine automatically restarts.

OPERATING INSTRUCTIONS

Step 1
Open the lid and take out the basket and add water to the reservoir.
Note: There is a maximum scale MAX in the reservoir. The water should not exceed the MAX position. If the water exceeds the maximum scale MAX, you need to open the bottom drain plug, release the excess water, and cover it with a transparent cover.
Step 2
Plugin the power, and press the POWER button to start the machine.
Step 3
Select the size of the ice you want to make, default big ice

Note

1. When the indoor temperature is lower than 15 degrees, please choose small ice. When the indoor temperature is higher than 30 degrees, it is recommended to choose big ice.
2. In the three cycles used for the first time, the ice produced is small and irregular.
3. When the ice basket is full, please take out the ice immediately. Do not let the ice overflow the ice basket.

CLEANING & USE GUIDANCE

1. Clean the inner liner, ice collecting tray, water box, ice shovel, and evaporator frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice maker. Do not spray the Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.

2. Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

3. Reuse the machine after being idle for a period of time, it may not have enough water to pump for air retard, and the indicator of “ADD WATER” will keep lighting. At this time, you just need to press the POWER button again, the machine can enter the normal state.

4. To ensure the cleanness of the ice, please change the water for the water reservoir at least once one day. If do not use it for a long time, please drain the water out and clean
   it up.

5. If the compressor takes a strike action for shortage water, fully water or interruption of power supply, it will delay for 3mins to start up after restart.

6. Always use fresh water before starting ice production either at initial installation or after a long shut-off period.

TROUBLESHOOTING

1. Please note, if a power failure occurs due to disconnection of the power cord, or the power button has been pushed off during an ice-making cycle, small ice chips may form and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel can not remove the ice from the ice basket. If not, please push the ice shovel gently with a finger, then press the POWER button to restart.

is normal.
The water shortage indicator light is on| 1. There is no water
2. The pump is full of air| 1. Add some water until it reaches the MAX position
2. Press the POWER button to restart
Indicator lights on the display is not on| Blown fuse/ No power| Replace fuse / Tum power on
The Ice made is too large and with pieces sticking together.| 1. water temperature is too low
2. Ice of previous cycles left in the water fray| 1Select small size
2. Take out the ice under the standby state
The ice-making procedure is correct, but there is no ice coming out.| 1. The compressor has no refrigerant.
2. Compressor damage
3. The fan motor is damaged.| Call the service hotline.
All indicators twinkle simultaneously| 1. The water box was blocked by ice.
2. The motor is stuck, or the motor is off, or the motor is damaged.
3. Micro switch damage.| 1. Unplug the power to take out the ice which blocks the tray, then plug the power and
press the POWER button, the machine will restart 3mins later.
2. Call the service hotline.
The machine is always working, but the water is always warming,| The solenoid valve has failed.| Replace the solenoid valve.
When the ice is full, the machine does not prompt ICE FULL| 1. Ice full sensor damage.
2. Solar ray interference.| 1. Replace the red ice full sensor.
2. Move indoors to make ice.
3. Call the service hotline.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.

MANUFACTURER & IMPORTER (UK)

Manufacturer:
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain:
Chal-Tec UK limited
Unit 6 Riverside Business Centre
Brighton Road
Shoreham-by-Sea
BN43 6RE
United Kingdom

References

• Klarstein | Your home. Your kitchen. Your style.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>