belkin D3Q 15W Wireless Charger User Manual
- June 5, 2024
- belkin
Table of Contents
belkin D3Q 15W Wireless Charger
Prouduct Specification
- Input: 5V-2A, 9V-2A, 12V-2A
- Output: 15W/10W/7.5W/5W
- Efficiency :80%(Max)
- Transmission Distance: 7mm
- Operating Temperature: 0-45C
- Standard: QI
Note: The above parameters are collected from the real result of testing phones, the actual parameters will be different due to factors such as the phone and the usage environment.
RFQ
- Charging Slowly/ Being Hot
- Please kindly check whether the phone puts the right charging zone (Picture 1)
- Please kindly check whether the adapter supports QC3.0;
- Please kindly check whether the phone Supports Ql;
- Please kindly check whether the temperature of the phone is beyond 35 C
Cannot work normally
- Please kindly check whether there are some metal substance during the phone and this charger, for example, the metal phone case or the metal ring;
- Please kindly check whether the phone
Attention:
- Please use QC3.0 adapters;
- Please keep the charger away from fire water; Children can not play it as a tool;
- Please do not disassemble it, or the factory is not responsible for the result;
- Please clean this charger by dry soft cloth; not a wet cloth or chemical
Using Guide:
- Power On: the light turns off after Red and green alternately flashing for 3S;
- Charging: Greenlight flashes
- Charged Fully: Green Light keeps on
- FOD Protection: RED light flashes
FCC Warning
This device complies with Part 18 of the FCC Rules.
IC WARNING
This device contains licence-exempt transmitter(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Refer to Part 18.213(c) and KDB 784748 Annex A section A.5:
- Max. Electric Field Emissions: 0.2817V/m Max. Magnetic Field Emissions: 0.3050V/m
- The maintenance of the system is the responsibility of the manufacturer.
- To prevent interference, the product should be as far away from devices operating at the same frequency as possible.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>