belkin WIZ023 BoostCharge Pro 3 in 1 Wireless Charging Stand User Manual
- June 1, 2024
- belkin
Table of Contents
belkin WIZ023 BoostCharge Pro 3 in 1 Wireless Charging Stand
Safety Instruction
WARNING. Failure to follow these instructions could result in a delay. electric shock, Injury, or damage to the user, product, or other property
- Connect the power supply of the wireless charger To a power outlet that Is close by and easy to disconnect from.
- Use Indoors and In a dry location only; Avold charging near sources al heat or humidity.
- Keep the wireless charger and power supply away from any liquids or moisture.
- Unplug the wireless charger when not In use for long periods of lime
- Do not store your device In very hot or ver? cold locations. It Is recommended to use your device at room temperature.
- Do not use If visible defec1s are observed on the wireless charger or power supply.
- Do not attempt to service, modify, or disassemble the wireless charger or power supply.
- Use of a power supply not recommended or sold by Belkin may result In an increased risk of fire, electric shock, Injury, or damage to the user, product, or other property.
- The wireless charging power transmission rate Is regulated by the wireless charging device receiving power which can be
Influenced by factors like, but not limited to proprietary charging protocols, ambient temperature, current battery percentage level and age of the device being charged.
CAUTION : If you experience problems with the wireless charger, Please
discontinue use, unplug the power supply from the socket and contact Belkin
for assistance.
The marking Information Is located on the bottom of the apparatus.
FCC Statement
DECLARAT ION OF CONFORMITY WTTli FCC RULES FOR ELECTROMAGNETIC COM PATIBI
LITY
We, Belkin International, Inc., of 555 S. Aviation Blvd .. Suite 180, El
Segundo, CA 90245, USA. Tel: +1(310) 751 5100, declare under our sole
responsibility that this product complies with Part 15 of the FCC Rules.
Operation Is subject to the following two conditions: (1) this device may not
cause harmful interference. and (2) this device must accept any interference
received, Including Interference that may cause undesired operation.
Federal CommUT1lcatlons Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device. pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference In a
residential Installation This equipment generates, uses, and can radiate rad
to frequency energy, and If not Installed and used In accordance with the
instructions, may cause harmful interference to radio communications. However.
there is no guarantee that interference will not occur In a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user Is encouraged to try and correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and the receiver.
- Connect the equipment to an outlet on different from that to which the receiver Is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 cm between the radiator and your body.
Innovation, Science. end Economic Development Canada Statement OSED):
this device contains licence-exempt transmitte receiver(s) that comply With
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s}.
Operation is subject to the following two conditions:
- This device may not cause Interference.
- This device must accept any 1nter1erence. Including interference that may cause undesired operation of the device.
Radiation Exposure Statement:
- This equipment comes with ISED radiation exposure limits set forth for an uncontrolled environment.
- This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body
Innovation, Science and Economic Development Ca nada Statement:
This digital apparatus complies with CAN ICES-003(B) /NMB-003(B).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>