Cloudy Bay CBSL11SMBK 11 Inch Round Low Profile Smart Ceiling Light Instruction Manual
- June 5, 2024
- Cloudy Bay
Table of Contents
Cloudy Bay CBSL11SMBK 11 Inch Round Low Profile Smart Ceiling Light
Installation Instructions
Component List:
- TURN OFF POWER SUPPLY BEFORE YOU START INSTALLATION!
- Use Philips screwdriver to fix MOUNTING BRACKET CC on junction box ( junction box excluded) with SCREW AA.
- Pull out live wire, neutral wire and ground wire from junction box, connect live wire to LIGHT UNIT’ s black wire, connect neutral wire to LIGHT UNIT’s white wire, connect ground wire to LIGHT UNIT’s bare cooper wire with BB, or fix both ground wires on mounting bracket’s green screw firmly.
- Approach LIGHT UNIT to the MOUNTING BRACKET CC, till LIGHT UNIT’s center hole go through screw stem , adjust stem’s length and tighten it with hex nut one, fix LIGHT UNIT with another hex nut two.
- Apply silicone caulking adhesive (not included) completely around the perimeter of the fixture where the back meets the mounting surface to prevent water from seeping into the junction box.
- Installation is completed, please go ahead to USER MANUAL & VOICE CONTROL GUIDE EE to complete setting.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
To comply with FCC RF exposure compliance requirements, this grant is
applicable to only mobile configurations. The antennas used for this
transmitter must be installed to provide a separation di stance of at least
20cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>