HOSELINK 651N Stand-up Weed Puller User Manual
- June 5, 2024
- HOSELINK
Table of Contents
User manual
MODEL: 6581N Stand-up Weed Puller
Assembly Instructions
STEP 1:
Remove all hardware from the package. This should include two long bolts, two
small screws, four washers, and two Allen keys as pictured.
STEP 2:
Remove and discard the black plug from the bottom section of the Weed Puller
(this is there for shipping purposes only).
STEP 3:
‘Push the top handle into the base of the Weed Puller. Please note, that
this will only attach in one direction.
STEP 4:
Place one washer over the long bolt and push through one side of the
fixture hole. Place a washer over one small screw and insert it into the other
side of the bolt. Tighten with the two Allen keys simultaneously.
STEP 5: Repeat the process for the remaining hole. Now you are ready to
get the wedding!
Instructions
STEP 1:
Place the claw over the center of the weed. This is important as you want to
remove the entire root.
STEP 2: Press down on the foot peddle until it is level with the grass.
STEP 3:
Pull the Weed Puller away from the weed onto the foot peddle. This will close
the claw around the weed.
STEP 4:
Continue to lean the handle of the Weed Puller back until the weed has lifted
from the ground.
STEP 5:
Hold the green rubber grip on the handle and push down to open the claw and
eject the weed.
TIP
Rinse or wipe the claws clean after use to prevent any dirt from building up
inside the mechanism.
For more information vishoselink.com
or call 1300 900 617
Cultivating Connections
Documents / Resources
|
HOSELINK 651N Stand-up Weed
Puller
[pdf] User Manual
651N, Stand-up Weed Puller, Weed Puller
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>