HUMANTECHNIK A-2552-0 Call Detector for Mobile Phones User Manual

June 5, 2024
HUMANTECHNIK

HUMANTECHNIK A-2552-0 Call Detector for Mobile Phones User Manual
HUMANTECHNIK A-2552-0 Call Detector for Mobile Phones

Congratulations on purchasing your »iBell-2«. We hope it will provide you with many years of service. You have chosen a modern and reliable system. Please read through these operating instruction carefully to be able to start the unit correctly and to familiarise yourself with all of the systems features.

Standard components

Please check if all following components are included:

  • »iBell-2«
  • 3x 1,5 V AA batteries
  • Connection cable
  • Operating Instructions
  • Warranty card

If any parts are missing please immediately contact your dealer or the manufacturer directly.

Safety instructions

  • Place the device on a non-slip surface that does not vibrate.
  • Ensure the leads cannot cause any accidents.
  • Keep the device away from the following:
    • Sources of heat
    • Direct sunlight
    • Humidity
  • Protect your device from moisture, dust, aggressive liquids and vapours.
  • Only connect the power leads to the appropriate jacks.
  • Only connect authorised accessories.
  • Never:
    • open the device yourself;
    • carry the device by its leads.

Controls

Controls Controls

Component Function
Battery compartment Contains 3x AA batteries
Battery indicator A red light will blink, indicating that batteries need to

be replaced
Reset button| Confirms a call or text message has been received
Illuminated area| Blinks as soon as the mobile phone has received a call or a text message
»AUX« Connection socket| To connect the »iBell-2« with the lisa signalling system or additional modules such as a vibrating pillow.

How it works

When the mobile phone on the »iBell-2« cradle receives a text message or phone call, white LED lights begin flashing brightly in the front and back panels. For the first two minutes, after a call or text message comes in, the light flashes rapidly. After two minutes, the pace of the flashing decreases, conserving battery power, until it completely disappears after 3 hours.

Inserting the batteries

The device needs three 1.5 V batteries (AA type) to work.

To insert the batteries, proceed as follows:

  1. Remove the securing screw of the lid of the battery compartment on the bottom of the »iBell-2«. Unhinge the battery compartment lid.
  2. Now insert three AA type batteries into the battery compartment. Ensure the right polarity is selected for the batteries.
  3. Now close the battery compartment lid and replace the securing screw. As soon as the batteries have been inserted, the white chaser light on the »iBell-2« will briefly blink.

Battery Level Indication (Self Test):

Use the self-test function to verify that your »iBell-2« is powered on, and the batteries are working properly: While the »iBell-2« is idle, simply press the reset button. »iBell-2« will then blink twice to indicate that the unit is in operation.

Low Battery Indicator:
An incessantly flashing red light indicates that battery power is low. If the battery power becomes too weak for the device to operate, it switches off automatically. If the battery level indicator flashes repeatedly, please change the batteries, as the »iBell-2« may cease to function until they are replaced.

Positioning the »iBell-2«

Place the »iBell-2« on a flat, non-vibrating surface.
Suitable surfaces: tables, shelves etc.
Unsuitable surfaces: tumble dryers, washing machines etc.

Positioning the mobile phone

  1. Switch your mobile phone to vibration alarm. If your mobile phone has variable vibration settings, select the alarm with the longest and strongest vibration.
  2. Carefully place your mobile phone onto the »iBell-2« cradle. Please note: if the mobile phone is not inserted carefully, the movement may be interpreted as a vibration, causing »iBell-2« to trigger its light. Should this happen, press the Reset button to acknowledge the signal.

Call/text message received confirmation

After receiving a call or a text message, you must confirm it has been received so that the »iBell-2« can report new calls or text messages. Press the reset button on the front of the »iBell-2« to acknowledge the signal. The device has now been reset and can report new calls and text messages again.

Connecting the »iBell-2« with Humantechnik alerting systems

The »iBell-2« can easily be connected to the Humantechnik alerting systems »lisa RF« and »signolux«. Alerting systems consist of at least one transmitter and one receiver.

lisa RF:
Connect the »iBell-2« to the »lisa RF telephone transmitter acoustic« (not included) via the included connection cable.

Signolux:

Connect the »iBell-2« via the included connection cable to socket #1 of the »signolux Acoustic Universal Transmitter« (not included).
Signolux

The transmitters register the »iBell-2« signal and convert it into a radio signal. These wireless radio signals are transmitted to the according receivers, which then indicate the event.

Please note : Devices of the alerting system »lisa RF« cannot be combined with devices of the alerting system »signolux«.

Sensitivity adjustment of »lisa RF telephone transmitter acoustic« and »signolux Acoustic Universal Transmitter

Set the sensitivity control of the according transmitter to the highest setting (turn clockwise until limit). The transmitter will now react upon the vibration alarm of the mobile phone

Connecting additional modules to the »iBell-2«

Signal emitter modules (vibrating pillow, flash module MF-1, acoustic module MA-1 or switch module MS-1) can be connected with the »iBell-2« via its connection socket on the rear. Plug one end of the supplied lead into the AUX connector socket of the »iBell 2« and the other end of the lead in the module’s connection jack.

Battery life

Battery endurance my vary strongly, according to the quality of the batteries purchased. Under normal conditions, a set of new batteries should last approx. 6 months and more.

Troubleshooting

Symptoms Possible causes/remedy
The  »iBell-2«  does not blink when a call/text message has been received.

Check whether the batteries have been inserted correctly and are fully charged.

Check whether the longest and strongest vibration alarm has been set on your mobile phone.

»iBell-2« blinks although no call and/or text message has been received.| The device is very close to a strong wi­reless signal.

Press the reset button and put the mobile phone back in the housing.

The device was placed on an uneven or vibrating surface (e.g. worktop with kit­chen equipment).

The mobile phone was not placed in the housing carefully.

The red LED under the reset button is constantly blinking.| Battery indicator: Insert new batteries.
I have connected the »iBell-2« with a wireless Humantechnik alerting system, but it is not triggering.| Ensure that the »iBell-2« is connected to an „acoustic” transmitter. Ensure that all the leads are connected properly. Adjust the sensitivity to the highest setting.

Maintenance and care

If the unit does become dirty, simply wipe it clean with a soft, damp cloth. Never use spirits, thinners or other organic solvents. Do not set up the »iBell-2« where it will be exposed to full sunlight for long periods. In addition, it must be protected against excessive heat, moisture and severe mechanical shocks.

Note

This product is not protected against splash water. Do not place any containers filled with water, such as flower vases, or anything with an open flame, such as a lit candle, on or near the product. Please make sure that the batteries are not exposed to excessive heat from such as sunlight, fire or anything similar.

Warranty

This product is very safe to operate and provides highly reliable service. Should a malfunction occur despite the unit having been set up and operated correctly, please contact your dealer or the manufacturer directly. This warranty covers the repair of the product and returning it to you free of charge. It is essential that you send in the product in its original packaging, so do not throw the packaging away. The warranty does not apply to damage caused by incorrect handling or attempts to repair the unit by people not authorised to do so (destruction of the seal on the unit). Repairs will only be carried out under warranty if the completed warranty card is returned accompanied by a copy of the dealer’s invoice/till receipt.

Always specify the product number in any event.

Environmental note / disposal

Disposal of used electrical and electronic equipment (applicable in the countries of the European Union and in other European countries which operate a separate collection system for these devices). The symbol on the product or its packaging indicates that this product should not be treated as normal household waste. It should be handed in to a collection center for recycling electrical and electronic equipment. By playing your part in ensuring the correct disposal of this product, you will be safeguarding the environment and the health of other people. The environment and health are jeopardized by incorrect disposal. Material recycling helps to reduce the consumption of raw materials. You can obtain further information about recycling this product from your local council, from local waste disposal operators and from the shop where you bought the product.

Technical data

  • Power supply: 3x 1,5 V AA batteries
  • Height: 145 mm
  • Diametre: 120 mm
  • Weight: 240 g incl. batteries

CE symbol

This device satisfies the according EU directives. Compliance with the directives listed above is confirmed by the CE seal on the device. CE compliance declarations are available on the Internet at: www.humantechnik.com/service

Technical specifications subject to change without notice.

Humantechnik Service-Partner

Germany: Humantechnik GmbH
Im Wörth 25
D-79576 Weil am Rhein

Tel.: +49 (0) 76 21/ 9 56 89-0
Fax.: +49 (0) 76 21/ 9 56 89-70
E-mail: info@humantechnik.com

Switzerland

Humantechnik GHL AG Rastatterstrasse 9 CH-4057 Basel

Tel.: +41 (0) 61/ 6 93 22 60
Fax.: +41 (0) 61/ 6 93 22 61
E-mail: info@humantechnik.com

France
Belgium

SMS Audio Electronique Sàrl
173 rue du Général de Gaulle
F-68440 Habsheim

Tel.: +33 (0) 3 89/ 44 14 00
Fax.: +33 (0) 3 89/ 44 62 13
E-mail: sms@audiofr.com

Netherlands

Hoorexpert BV
Gildenstraat 30
NL-4143 HS Leerdam

Tel.: +31 (0) 3 45/ 63 23 93
Fax.: +31 (0) 3 45/ 63 29 19
E-mail: info@hoorexpert.nl

For other service-partners in Europe please contact:

Humantechnik Germany
Tel.: +49 76 21/ 9 56 89-0
Fax: +49 76 21/ 9 56 89-70
Internet: www.humantechnik.com
e-mail: info@humantechnik.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals