SPA FROG In-Line System Instructions

June 5, 2024
FROG

SPA FROG LOGO SPA FROG ®
In-Line System
Operating InstructionsSPA FROG In Line System

Please read the product label and attached leaflet before using it.
This hot tub in-line system contains two parts:

  1. A bromine cartridge for disinfection
  2. And a conditioning cartridge for softer feeling water.

Hot Tub Start-Up

  • Always drain and refill the spa at least every 4 months.

  • Clean and replace filter cartridges when dirty
    (Follow manufacturer’s instructions).

  • Balance water according to the chart.
    WATER BALANCE GUIDELINES

    pH:| 7.2 – 7.8
    Total Alkalinity:| 80 – 120 ppm
    Calcium Hardness:| 150-250
    Total Dissolved Solids:|  <1500
    Free Bromine:| 3.0 – 5.0 ppm

  • Heat water to recommended temperature before using cartridges.
    Very Important! Before using cartridges, establish an initial residual of 3.0 – 5.0 ppm bromine or chlorine with a granular brominating concentrate (which typically contains 85% sodium dichlor (chlorine) and 15% sodium bromide) OR a chlorine shock.
    DO NOT use a non-chlorine shock.

  • Begin Regular Hot Tub Care procedures (see page 5) as soon as the start-up is complete.

Setting Cartridges

Set the blue Conditioning Cartridge to wide open on #6 by holding the bottom and turning the top until the number 6 appears in the setting window.
No further adjustments are necessary.

SPA FROG In Line System - FIG 1

Set the yellow Bromine Cartridge per the chart.
The next day, check the bromine level. If needed, adjust the setting 1 number up or down and test again in 24 hours. Continue until the bromine level stabilizes to at least 3.0 ppm.

Bromine Setting Chart

756 Liters| 0
945 Liters| 1
1,134 Liters| 1
1,323 Liters| 2
1,512 Liters| 3
1,701 Liters| 4
1,890 Liters| 5
2,079 Liters| 5
2,268 Liters| 6

Using the In-Line System

  1. Remove cap and pull holder out of the system.
  2. Insert both cartridges into the in-Line holder with the bromine on the bottom.
  3. Insert the holder into the in-line System by pushing down and turning to the right. Then replace the cap.

Replacing Cartridges

| The SPA FROG Conditioning Cartridge should be replaced every 4 months or when draining and refilling the spa with fresh water.
---|---
| Replace the SPA FROG Bromine Cartridge when empty. Drain water to ensure the cartridge is empty then discard it in the trash. The cartridge life will vary depending on hot tub size and the number of users.

Regular Hot Tub Care

  1. Run filtration system as recommended by your hot tub manufacturer.
  2. Regularly test the water with test strips for pH, total alkalinity, and bromine levels.
  3. Maintain a 3.0 – 5.0 ppm bromine level at all times.
  4. Shock the hot tub once a week or as needed. Additional shocking may be required if the hot tub is under heavy use. This is often the case when the hot tub is new. 
  5. Remember to replace SPA FROG Conditioning Cartridge and SPA FROG Bromine Cartridge as directed under “Replacing Cartridges.”

MANUFACTURED BY 530 11th AVENUE SOUTH
HOPKINS, MINNESOTA 55343 U.S.A.
001-952-933-6118
20-48-0299. 553122043N

Documents / Resources

| FROG SPA FROG In-Line System [pdf] Instructions
SPA FROG In-Line System
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

FROG User Manuals

Related Manuals